1 33311 eng doorphone door access communicator instruction manual kx-t927 please read this manual carefully before using the product. Kx-t927-mtl mt proxy kx-t927-mtl-rfid.
2 1. Parts and functions screws camera speaker red anti vandal keypad microphone screws 2. General tador doorphone the doorphone unit is an intelligent telephone connected to telephone exchange, mounted on office entrance and enables visitors to call to a predefined extension. Person receiving a cal...
3 4. Set lock type connect jumper jm1 according to type of lock you using. (see picture) jumper jm1 is placed on the right side at the middle of the electric board jumper mode lock type jumper on two top pins magnetic lock (normally close) jumper on two button pins electric lock (normally open) 5. B...
4 6. Programming tador doorphone modes (doorphone extension). A. Remote programming from pbx extension data can be programmed through the pbx extension telephone. 1. Enter extension programming mode – to enter programming mode follow the next steps dial from any telephone to the extension of the t...
5 4. Dial symbols ) hash # ) 2 * pause 5 * ) asterisk * ) 3 * in the two push button, and four button tador doorphone model kx-t927-av-2p/4p, to program the push button from 1 - 9 use the cell consecutively from 41 - 49 5. Settings relay strike time for the first relay – (default 3 seconds). Example...
6 8. Camera relay strike – set the camera relay strike time (play time, default 30 sec). Example: change the camera uptime to 40 seconds. Enter remote programming mode, enter cell number 14, followed by the new value you want to set 40(two digits), and then press hash (#) key to approve. B. Connecti...
7 11. Rfid – proximity card programming the device could be programmed with up to 150 rfid cards the rfid initialization should be done for virgin device, follow: 11.1. Add rfid card follow the below instruction: a. Dial from any telephone to the extension of tador codephone. B. Press the hash key t...
8 11.2. Rfid – proximity card erasing or replacing (remove programmed card and set new one instead) for erasing/replacing rfid card you have know the memory sell number where card have been stored a. Dial from any telephone to the extension of tador codephone. B. Press the hash key twice (#, #) (the...
9 c. Initiating tador doorphone – clear all memory in order to reset the tador doorphone from all its memory including speeds dial access codes and restore all settings to default values. Follow these steps: 1. Disconnect the power supply from the doorphone. 2. Install jumpers on def connector betwe...
15 e. Drawing 12ac proxy board mic volume mic rmt -12v + line telephone extation electric lock relay spk volume spk cam button connector bypass pushbutton n .O n .C j m 1 d e f prg for programming and restore move the jumper up for restoring device add jumper on prg remove the jumper after restore c...
11.
12 thank you for choosing our products www.Tador.Com all rights reserved to tador technologies ltd©.
