TAG Heuer Formula 1 CAH1110.BT0714 User Manual - page 6
13
This function measures two times that occur in rapid succession.
Warning: Before each timing, the hands must be at zero. If necessary,
press button B.
1.
Start:
button A (START)
2.
Measure 1st time:
button B
3.
Measure 2nd time:
button A (STOP)
>
Read 1st time
4.
Call 2nd time:
button B
>
Read 2nd time
5.
Reset to zero:
button B
C a l c u l a t i o n o f t w o c o m p a r e d t i m e s
S e t t i n g t h e h a n d s o f t h e c h r o n o g r a p h
After a battery change, or if the function should be affected by a severe
knock or exposure to a strong magnetic field, the hands of the chronograph
should be reset at zero (starting point).
Resetting the seconds-hand and the 1/10th-second register:
1.
Put the crown to position 3 (this position stops the watch)
2.
By means of short, successive pressures on the button, turn the hands
step by step back to zero:
Button A:
works the seconds-hand
Button B:
works the hand of the 1/10th-second register
Resetting the hours register and minutes register:
1.
Put the crown to position 2
2.
By means of short, successive pressures on the button, turn the hands
step by step back to zero:
Button A:
works the hours register
Button B:
works the minutes register
Note: Do not keep the crown in position 2 for more than 20 minutes (loss of
hour).
Remember always to push back the crown and screw it in to
position 0.