TAG MCLAREN AUDIO 250MR Owner's Manual - page 9
set-up
|
17
16
|
set-up
Before making any connections ensure that the mains plug is
removed from the rear panel power socket
You will require an av processor, such as the AV32R or a preamplifier, such as the DPA32R
to provide the signal to drive the 250MR.
power connection
loudspeaker connection
The contacts of the loudspeaker terminals of this amplifier (marked with the
lightning symbol) have hazardous live voltages present. If in any doubt, consult
a qualified electrician before making connection to these terminals.
On the rear panel of the 250MR you will find a pair of loudspeaker
terminals. The terminals are designed to accept high quality
8 mm spade connectors. Use only high quality ready made cables
with insulated spade connectors such as the TAG McLaren Audio
F3-10-SPK.
Ensure that the amplifier mains plug has been removed from the
wall socket before connecting the red (+) terminal of the
loudspeaker to the red terminal on the rear panel of the 250MR. In
turn connect the black (–) terminal of the loudspeaker to the black
terminal on the 250MR.
When making the connection, ensure that the spade terminal is
correctly located and the loudspeaker terminal is fully tightened.
av processor or preamplifier connection
Make sure the av processor/preamplifier and all connected source units, such
as a CD player are switched off and their mains plugs have been removed
from the wall sockets.
The 250MR provides a single ended line input (RCA) and a balanced XLR connection.
Do not connect XLR and RCA at the same time to an external source as this
will cause severe distortion and can damage your equipment.
Do not leave an un-terminated cable attached to an unused input.
GRR00794.03-UK 250MR 5/4/02 11:49 am Page 16