Tahoe 50200058 Instruction Manual - page 3
5
2
ASSEMBLY INSTRUCTIONS
OPERATION
A
B
C
Figure 1
Attach the Wand (Figure 1)
1. Rotate wand nut (A) counter clockwise
to loosen.
2. Insert the wand shaft (B) through the nut and
into the handle (C) until it bottoms
3. Rotate wand nut clockwise to secure wand.
Filling the Tank (Figure 2)
1. With the pump handle (A) in the down position,
rotate counterclockwise to loosen.
Remove the pump.
Warning: Do not open bottle until pressure has
been released.
2. Fill tank according to the manufacturer's
instruction for the chemical being used.
Caution: Do not exceed "Max Fill" Line
3. Replace the pump. Rotate handle clockwise
to tighten.
Figure 2
A
Pressure
Release
Valve
Max. Fill
MAINTENANCE AND STORAGE
1. Empty and clean tank, pump and wand after each use with mild soap and water. Spray soap
and water solution through nozzle, hose and controller to remove all traces of chemicals.
2. Rinse thoroughly inside and out with clean water. Spray clean water through nozzle, hose
and controller.
3. Allow all parts to dry before storage. Store sprayer in a dry area out of reach of children.
4. Once a year, lubricate pump O-ring with petroleum jelly or water proof grease.