Taiden HCS-8316 series Installation And Operation Manual - page 12
3.5 Select LineIn (
for
HCS-8316VGA-H/AV-H/SDI only)
a). Use the “Õ/Ö” button to switch between “LINE IN1”
and “LINE IN2”;
b). Press the “MENU” button to confirm and to return to
the upper level menu.
3.6 Line in Volume
Adjust line in volume, range: MUTE, -30 dB - 0 dB.
a). Press the “Õ/Ö” button to adjust volume;
b). Press the “MENU” button to save and return to the
upper level menu.
3.7 Rename
Set alias for the encoder with a maximum length of 16
characters or less. It is convenient to identify them on the
operation of room combiner.
a). Press the “MENU” button to enter the name setting
interface, the cursor blinks under the first character;
b). Press the “Õ/Ö” button to move the cursor;
c). Press the “MENU” button to modify the character;
Press “Õ” clear all the characters after the cursor;
press the “Ö” button to select the new character;
d). Press the “MENU” button to save at each character;
e). Press the “EXIT” button to return to the upper level
menu after setting finished.
3.8 Save Parameter
a). Press “Õ/Ö” to select save parameter or not;
If “Y” is selected, system parameters can be saved;
If “N” is selected, system parameters cannot be
saved;
b). Press the “MENU” button to confirm and to return to
the upper level menu.
3.9 Set SDI loop (for HCS-8316SDI only)
a). Use the “Õ/Ö” button to enable SDI loop or not;
b). Press the “MENU” button to confirm and to return to
the upper level menu.
3.10 Video Input (for HCS-8316HDMI only)
a). Use the “Õ/Ö” button to switch between “HDMI” and
“DVI”;
b). Press the “MENU” button to confirm and to return to
the upper level menu.
3.11 Audio Input (for HCS-8316HDMI only)
a). Use the “Õ/Ö” button to switch among “a. Line In 1”,
“b. Line In 2” and “c. HDMI”;
b). Press the “MENU” button to confirm and to return to
the upper level menu.
3.12 Default (for HCS-8316HDMI only)
c). Use the “Õ/Ö” button to select default or not;
d). Press the “MENU” button to confirm and to return to
the upper level menu.
3.13 About
Encoder information includes: firmware version and
series number, shown as in the following figure - press
the “MENU” or “EXIT” button to return to the upper level
menu.
6