Taiji TST-100A Instruction Manual
Thank you for purchasing of our thermometer this time.
Before use, please read this manual carefully, and please
use the thermometer correctly and safely. After reading,
please keep and refer to it any time as important information.
Instruction manual
Model:TST-100A
Battery replacement
(battery type: Lithium battery CR2032 × 1 pc.):
Pre-cautions for use:
1) This product is not waterproof structure. Except for SENSOR PROBE part, do not put
detergent, or avoid washing or soak in water.
2) Do not use the product near static electricity or electromagnetic waves as such as
IH cookers and microwave ovens etc. It may cause of failure or malfunction.
3) Do not place the product in high temperature and magnetic location.
4) Do not give heating, dismantle, electric charging, remodeling to the product. Also
avoid using it in water or fire.
5) Dropping or giving shock may cause malfunction on the product.
6) SENSOR PROBE of the product is applicable for temperature range -50°C ~ + 300°C.
Therefore, use of outside this range will cause of failures.
7) As a main body of the product is made of plastic resin, do not apply fire directly or
do not put it in a place of becoming high temperature.
8) Do not hang the product on a hook wearing SAFETY CAP on it. Also, do not swing
it with SAFETY CAP.
9) SENSOR PROBE is a skewer-shaped; there is a risk of injury by wrong handling. Pay
enough attention to use. Put SAFETY CAP to SENSOR PROBE tip when no use. Keep it
away from a reach of children.
10) Since this product is designed for measuring Sake temperature, do not use it for
human being body temperature measurement.
Pre-cautions for use:
When battery power becomes weak and need to replace it,
if press the “POWER” BUTTON, “LO” and BATTERY MARK are
indicated on DISPLAY as per a right figure. Replace the battery
with following way:
1) Turn BATTERY COVER towards “OPEN” direction by a coin, and remove the cover.
Caution: Open the cover carefully as there is a risk to crush the coin slot for impossible
to open the cover.
2) Insert the flat-blade screwdriver tip to a gap of battery housing to lift up an
old battery to take it out (see Fig. 1). Check the polarity of new battery (+, -),
then put the new one correctly (see Fig. 2).
Caution: Plus “+” side must be face up position. The battery leakage may be
occurred if wrong polarity setting.
3) Set BATTERY COVER to match concave notches of housing side and convex
parts of cover side, then close the cover towards the "CLOSE" direction by a coin
(see Fig. 3).
Caution: Use the product after confirming that the BATTERY COVER is securely closed.
Caution: Since the accessory battery is for operation check, and its life may be shorter
than mentioned in this manual.
Caution: When take out a battery,
it may pop out suddenly.
Fig.1
Fig.3
Fig.2
Side View
of Battery
-Side(Bottom)
+Side(Top)
Recess
coin
Open
Close
BATTERY
COVER
Lithium Battery
Slot
Digital Sake thermometer
with alarm function
Back Side of
Battery Cover
Convex
Portion
Part name
SAFETY CAP
DISPLAY
BATTERY COVER
“POWER” BUTTON
“SET / STOP” BUTTON
“+” BUTTON
“-” BUTTON
SENSOR PROBE
Front view
Rear view
Display
MEASURED TEMP.
(CURRENT TEMP.)
SETTING TEMP.
ALARM
MARK
BATTERY
MARK
Caution: Battery should put into underneath
of the guides through with plus “+” face up.
Gap
Flat-blade
screwdriver
Guide
Guide
Body
Taiji Overseas Sales dept.
Okawa-cho 8-2, Kawasaki-ku, Kawasaki-city, Kanagawa
210-0858, JAPAN
Tel: 81-44-329-6338
E-mail: overseas@taiji.co.jp
http://www.taiji.co.jp/e
● Do not short-circuit, dismantle a battery. Do not apply heating. Also, do not attempt
to incinerate. It may be cause for heat up, leakage or rupture.
● Keep the battery away from a reach of children. If children swallow it, consult to a
doctor immediately.
● When abandon or discard an used battery or keep a fresh battery, put electrode
insulator to it with as such as taping. Contacting electrode with other metals and
batteries it may case for ignition and rupture.
Warning about battery:
Make sure following points for safety use. If misuse of battery, it will cause of failure of
the product. There is a risk of leakage and rupture for injury.
● Put battery polarity (+, -) correctly.
● Remove the battery from the product when if it is not used for a long time.
● When disposing of batteries, follow the instructions from local society.
Caution for battery:
Display: LCD (liquid crystal display), 6-digit
Display unit: 1°C
Display temperature range: -50~ + 300°C
Applicable sensor probe temp. range: -50~ + 300°C
Guaranty operating temp. and humidity range:
0~ + 40°C, less than RH 85% (with no condensation)
Accuracy: ±1°C for 0~ + 50°C range
±2% (±4~±6°C) for + 200°C or above
±2°C for other range
Alarm sounding time: about 60 seconds
Auto power off time: about 10 minutes at no button operation.
about 60 minutes at alarm mode setting.
Drip-proof performance: JIS C 0920 IPX2 or equivalent
Battery: Lithium battery CR2032 × 1 pc.
Above product specifications are subject to change without notice for improvement.
Product Specifications: