Taiyo mini suzuki rm250 Owner's Manual - page 2
SETTING UP BIKE STAND
For Customers
The display stand can only be used when battery holder is installed.
Please insert the stand between rear of the battery holder and the vehicle.
1. FEATURES
FRONT VIEW
REAR VIEW
TRANSMITTER
2. BATTERY INSTALLATION
VEHICLE
Fig 1
Fig 3
Fig 2
Fig 4
Fig 5
1.Turn your vehicle over. Rotate the battery latch to release
the battery holder. Slide the holder toward the latch.
2.Lift the battery holder out of the vehicle.
3.Insert 4 AA alkaline (LR6) batteries into the battery holder,
with polarity ( / ) as shown on the holder.
4.Replace the battery holder in the vehicle.
5.Rotate the latch until it clicks shut, locking the holder in
place.
For Customers
Use only AA alkaline (LR6) batteries.
* Estimated run time for this vehicle: 60 minutes
Rider
Battery Holder
(Detachable)
Rear Working
Suspension
Front Working
Suspension
Battery Latch
ON/OFF Switch
Side Stabilizer
(One each side)
Gyro Stabilizer
(Inside rear tire)
Antenna
Right Stick
(Control Steering)
Left Stick
(Controls forward,
stop and braking)
Bike Stand
(Please detach
while driving)