Tally Dascom 7010 Installation Manual

Page of 4

Download

Bookmark us

Installation Guide

7010 Peeler Unit

This guide is provided for use by service representatives who must install the

peeler unit. If the peeler is not installed, please contact your supplier.

(1)

Check to make sure that the printer's power switch is turned off then disconnect the

power cord.

(2) Open the top cover and lift the thermal printhead and sensor arm.

(3) Remove the operation panel on

the front of the printer (2 screws).

When doing this, remove the

flexible cable that is connected

to the operation panel.

(4)

Remove the front right cover on

the front of the printer. (2 screws)

Head open lever

Sensor arm open lever

Thermal printhead

Flexible cable

Sensor arm

Top cover

Operation

panel

Front right

cover

Note

Installation requires a cross-point ('Phillips') screwdriver with magnetic tip and a

shaft at least 200 mm (8 inches) long.

Caution

1 2 3 4 Next › »

Page 1
Installation guide 7010 peeler unit this guide is provided for use by service representatives who must install the peeler unit. If the peeler is not installed, please contact your supplier. (1) check to make sure that the printer's power switch is turned off then disconnect the power cord. (2) open ...
Page 2
(6) remove the plastic cover from the front center cover that you have removed. (2 screws) note the plastic cover that you have removed is needed if the peeler unit is de-installed, so store it carefully. (7) attach the peel guide plate to the front center cover taking care not to over-tighten the s...
Page 3
Release knob peeler unit alignment holes and pins (8) attach the connector of the peeler unit to the daughter board as shown in the figure. Note the connector cannot be connected if it is inserted in the wrong orientation unless force is used! Check the orientation of the connector carefully. (9) sl...
Page 4
© copyright dascom europe gmbh v1.0 (12) attach the front right cover removed at step 4 in its original position. (2 screws) (13) attach the operation panel removed at step 3 in its original position. (3 screws) note b e sure to c o n n e c t t h e f l ex i b l e c a b l e t h at yo u d i s c o n n ...