– 1 – 7106 7206 7010 installation guide ethernet interface.
© august 2010 dascom europe gmbh.
– 3 – installation guide en replacing the interface board 1. Remove the two screws that fix the bracket of the parallel interface board to the printer. Then gently pull the interface board towards you. When you do this, be careful not catch or damage the connecting cable. Do not pull the cable too m...
– 4 – 2. Remove the connecting cable from the interface board and reconnect the cable to the connector of the new interface board. 3. Insert the interface board into the printer so that the connecting cable does not catch on the printer. The new board is slightly larger than the original board, so t...
– 5 – 5. To test the interface board’s correct operation, connect the power cord and the ethernet cable to the printer, insert some standard media, preferably 4” x 4” labels, (100mm x 100mm), then switch on the power. 6. Briefly press the blue button visible on the new interface’s bracket. This will...
– 6 – 8. To configure the network board, you can use the “printserver network tools” included on the cd supplied with the printer. However, the easiest way to configure the board is to use a web browser, such as internet explorer, running on a pc connected to the same network. 9. If you have a “dhcp...
– 7 – 10. On the self-test, under the tcp/ip section, there will be a line saying “ip address” together with four groups of digits separated by dots. It should also say “asigned by dhcp” next to it. 11. Start “internet explorer” or a similar web browser on a pc connected to the same network. When en...
Dascom representatives germany dascom europe gmbh heuweg 3 d-89079 ulm deutschland tel.: +49 (0) 731 2075 0 fax: +49 (0) 731 2075 100 www.Dascom.Com singapore dascom ap pte ltd 21 bukit batok crescent # 29 - 81 , wcega tower singapore 6 58065 phone: +65 6760 8833 fax: +65 6760 1066 www.Dascom.Com am...
