Talon Tools AB2206 User Manual - page 2
2
GB
EXTENSION CORDS
Make sure your extension cord set is in good condition.
When using an extension cord, be sure to use one heavy
enough to carry the current your product will draw. An
undersized cord will cause a drop in line voltage resulting
in loss of power and overheating. To reduce the likelihood
of disconnection of appliance cord from the extension
cord during operation, loop the extension cord through the
cord holder and secure on cord clip as shown in Figure A.
1. Always wear safety goggles or other suitable eye pro-
tection.
2. Always wear long pants, shoes and gloves. Do not
wear loose clothing, jewelry, short pants, sandals, or
go barefoot.
3. Always wear a respirator or face mask when working
with the blower in a dusty environment.
4. Always inspect the area before starting the appliance
to remove debris and hard or sharp objects that can
be blown or cause damage during operation.
5. Never operate this appliance when you are tired, ill or
under the influence of alcohol, drugs or medication.
6. Use only 240 A.C. voltage supply as shown on the
nameplate of the appliance.
7. Always run the appliance with the tubes attached to
the unit.
8. This appliance is intended for household use.
FIG. A
OPERATING INSTRUCTIONS
GB
BLOWER/VACUUM DESCRIPTION
1. Rear Handle
2. Two Speed on/off Switch
3. Front Handle
4. Car Vacuum Flexible Tube
5. Crevice Tool
6. GardenVacuum/Blower Tube
7. Mode Control Slide
8. Motor Housing
9. Speed Cleaner Head (AB2207S
Supplied) (AB2206 Optional)
10. Vacuum Bag Frame
11. Vacuum Bag Assembly
12. T-nozzle
13. Shoulder Strap
14. Cord Clip
15. Cord Holder
1
2
3
4
7
8
11
13
10
12
5
6
9
• VACUUM/BLOWER TUBE ASSEMBLY
1. Remove the screw (A). Insert tube (B) into the blower
housing and replace screw (A). (Fig. 1A)
2. Insert speed cleaner head (C) to the tube (B). (Fig. 1B)
(AB2207S Supplied) (AB2206 Optional)
• SHOULDER STRAP
INSTALLATION
1. Attach the 2 strap clips to the 2
links in the rear handle. (Fig. 2)
2. With machine on operator’s
right hand side place shoulder
strap across chest and over
left shoulder.
3. Adjust strap length to position the end of the vacu-
um/blower tube 50-100mm above the ground.
• VACUUM BAG ASSEMBLY
To install vacuum bag:
1. Reverse the vacuum bag (B) and insert flat bend of
vacuum bag frame (C) into the slots on side of the vac-
uum bag connector (A). Frame will click into position
when properly fitted. (Fig. 3A)
2. Fold vacuum bag over frame, inserting front portion
over curved section of frame last. Close zip at base of
bag. (Fig. 3B)
3. Position front hook of vacuum bag connector in line
with groove in housing. Tilt bag connector up so that
the tube engages with outlet of main body. Push up so
that the release tab clicks over lug at rear of housing.
(Fig. 3C)
4. Fit loop at front of bag over hook on vacuum/blower
tube. (Fig. 3D)
3
ASSEMBLY INSTRUCTIONS
Fig. 1A
Fig. 1B
A
B
C
B
Fig. 2
SPECIFICATIONS
Model No. . . . . . . . . . . . . . . . . . . . . . . . . . . .AB2206 . . . . . . . . . . . . . . . . . . . . . . . .AB2207S
Input . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .240V~,50-60Hz,2000Watt . . . . . . . . .240V~,50-60Hz,2200Watt
Air Volume High . . . . . . . . . . . . . . . . . . . . .7.5 c.m/m . . . . . . . . . . . . . . . . . . . . . .7.5 c.m/m
Low . . . . . . . . . . . . . . . . . . . . . .5.4 c.m/m . . . . . . . . . . . . . . . . . . . . . .5.4 c.m/m
Air Velocity High . . . . . . . . . . . . . . . . . . . . .240 km/h . . . . . . . . . . . . . . . . . . . . . . .240 km/h
Low . . . . . . . . . . . . . . . . . . . . . .175 km/h . . . . . . . . . . . . . . . . . . . . . . .175 km/h
No Load Speed High . . . . . . . . . . . . . . . . . . .16,000/rpm . . . . . . . . . . . . . . . . . . . . .16,000/rpm
Low . . . . . . . . . . . . . . . . . . .12,500/rpm . . . . . . . . . . . . . . . . . . . . .12,500/rpm
Bag Capacity . . . . . . . . . . . . . . . . . . . . . . . . . .35 Litre . . . . . . . . . . . . . . . . . . . . . . . .35 Litre
Mulch Ratio . . . . . . . . . . . . . . . . . . . . . . . . . . .10:1 . . . . . . . . . . . . . . . . . . . . . . . . . . .10:1
Net Weight . . . . . . . . . . . . . . . . . . . . . . . . . . . .7.0 kg . . . . . . . . . . . . . . . . . . . . . . . . .7.5 kg
Fig. 3A
Fig. 3B
C
B
A
A
B
Fig. 3C
Fig. 3D
WARNING: ALWAYS SWITCH OFF TOOL
AND UNPLUG CORD FROM OUTLET
BEFORE REMOVING VACUUM BAG FOR
EMPTYING.
14
15