Talon Tools AC3100 Series User Manual
WARRANTY INFORMATION
GB
C H A I N S A W W A R R A N T Y
The benefits conferred by this warranty are in addition to all other conditions and warranties in respect of
this product which the consumer may have taken under the Trade Practices Act 1974 or by any legislation
of a State or Territory of Australia. This product is warranted by Talon Tools Australia (ABN 12 099 520
939)(the “Company”) to be free from defects in material and workmanship for a period of 24 months from
the date of original purchase. The Company during the period of the warranty, will at its option, and sub-
ject to the conditions stated herein, repair or replace without charge this product or any component part,
which upon examination by an Authorised Service Agent or by the Company is found to be defective.
Warranty conditions
This warranty will not apply:
(i) where this product has been subjected to misuse, abuse, accident or want of care;
(ii) where this product has been used for a purpose for which it was not designed or is not suited;
(iii) where the service of this product has been undertaken by a person not authorised by the Company
to carry out such work or where parts that have not been approved by the Company have been used;
(iv) where this product has been used for industrial purposes.
Should service become necessary during the warranty period, the purchaser should contact an Authorised
Service Agent or the Company. In order to obtain warranty service, the purchaser must present the store
receipt showing the name of the retailer and the date of purchase together with a completed Warranty
Card. The period of the warranty begins from the original date of purchase, notwithstanding any subse-
quent repair or parts replacement. No additional warranty or guarantee other than set out in this document,
whether written or verbal, is authorised to be made on the Comapany's behalf. The purchaser shall be
responsible for delivery or causing the product to be delivered to the Compnay or the Authorised Service
Agent and the purchaser shall be responsible for all charges in connection with re-delivery of the product
and/or the delivery of parts. Damage in transit is not covered by this warranty and purchasers should
remove from the product any liquids (if applicable) before sending and pack the product securely to pre-
vent damage.
Warranty exclusions
Normal wear parts or components are subject to seperate terms as follows: Normal wear parts,
components or service required when performaing normal and regular maintenance of this
product are not covered by warranty unless it is found to be defective by an Authorised Service
Agent or by the Company. Normal wear parts include, but are not limited to:
Chains.
Chain Bar.
Spark Plugs.
Carburetor Adjustments.
Lubricants.
Engine Tune-ups.
Filters.
Returns based on the above listed normal wear parts will not be accepted under this warranty as they
are considered consumable items and are at the expense of the purchaser.
Model No. AC3100 (Series)
USER MANUAL
Petrol Chain Saws
23.4Þ
CKA
S
SA
AF
FE
ET
TY
Y O
OP
PE
ER
RA
AT
TIIO
ON
N M
MA
AIIN
NT
TE
EN
NA
AN
NC
CE
E
WARNING • PLEASE READ
Beware of kickback. Hold chain saw firmly with both hands when using. For your own safety, please
read and follow the safety precautions in this manual before attempting to operate your chain saw.
Improper use can cause serious injury.
This product has been tested at a computed kickback angle (CKA) of no greater than 23.4 degrees.
9096-310008
© Jenn Feng Inc., 1975, 2001
1