Talon Tools AC311014 User Manual

Summary of AC311014

  • Page 1

    9096-311001 model no. Ac311014 user manual petrol chain saw warning • please read beware of kickback. Hold chain saw firmly with both hands when using. For your own safety, please read and follow the safety precautions in this manual before attempting to operate your chain saw. Improper use can caus...

  • Page 2

    3 au 2 general safety rules au warning! When using petrol tools, basic safety precautions, including the following, should always be followed to reduce the risk of serious personal injury and/or damage to the unit. Read all these instructions before operating this product and save these instructions...

  • Page 3

    4 au 1. Saw chain 2. Guide bar 3. Spark arrester screen 4. Chain brake lever / hand guard 5. Front handle 6. Starter handle 7. Stop switch 8. Safety trigger 9. Rear handle / boot loop 10. Oil tank cap 11. Fuel tank cap 12. Starter cover 13. Bucking spike 14. Bar retaining nuts 15. Muffler shield 16....

  • Page 4

    7 au 6 au to install saw chain: always wear heavy duty gloves when handling saw chain or making saw chain adjustments. 1. Spread chain out in a loop with cutting edges (a) point- ing clockwise around loop (fig. 4a). 2. Slip the chain around the sprocket (b) behind the clutch (c). Make sure the links...

  • Page 5

    Au 8 9 au • to start engine 1. To start the saw, push the switch (on/off switch) to the on (i) position. (fig. 9a) 2. Pull out the choke (a) to the point where it latches in place. (fig. 9b) 3. Push the primer bulb (b) 10 times. (fig. 9c) 4. Latch throttle advance: depress latch and hold (c) squeeze...

  • Page 6

    11 au 10 au • air filter to clean air filter: 1. Remove knob (a) holding air filter cover in place, remove the top cover (b) by loosening the cover retaining screws. Cover will lift off. (fig. 15a) 2. Lift the air filter (c) out of air-box (d) (fig. 15b). 3. Clean air filter. Wash filter in clean, w...

  • Page 7

    12 au 13 au 6. Reinstall a new spark plug. • carburetor adjustment the carburetor was pre-set at the factory for optimum per- formance. If further adjustments are necessary, please take your unit to the nearest qualified service technician. • storing a chain saw storing a chain saw for longer than 3...

  • Page 8

    Trouble shooting the engine problem unit won’t start or starts but will not run. Unit starts, but engine has low power. Engine hesitates. No power under load. Runs erratically. Smokes excessively. Probable cause incorrect starting procedures. Incorrect carburetor mixture adjustment setting. Fouled s...