Tamarack Technologies Dragon 100 Installation Manual - Wiring Instructions
buildings codes.
Note: A licensed Electrician may be needed. If unsure,
consult with your local Electrical Inspector.
WIRING INSTRUCTIONS
WARNING! Make sure that power supply is disconnected and locked to
prevent accidental activation.
1. Remove the screws securing the terminal box cover plate located on the fan
motor mounting bracket. All fan motor and capacitor connections are pre-wired
to the electrical terminal strip. A 3/8” romex type cable restraint connector will be
needed to secure the wiring through the knockout provided on the side of the
terminal box.
2. Bring incoming electrical service through the romex connector and the fan
electrical service opening. Using a small regular screwdriver, tighten the neutral
(white) wire of the incoming 115V power supply under the open terminal strip port
opposing the motor Blue wire. Tighten the line (black) wire of the incoming supply
under the open terminal opposing the motor Black wire. Now, secure the source
ground to the open terminal strip opposing the Green/Yellow Wire.
3. Secure the romex connector to the terminal box. Secure the incoming supply
using the romex connector. Replace the fan terminal box cover.
4. Apply a generous bead of silicone caulk around the electrical provision hole in
the backplate of the fan to provide for a secure seal.
CONTROLS
The Dragon can be controlled by several methods. A standard SPST wall switch
or 2, 3-way “hallway” switches. There are many wall mounted crank timers with
2,4 or 6 hour setting available. Some automatic garage door openers will allow
the Dragon to operate for a preset interval after the door opens or closes. Check
with the manufacturer of your door opener about these options.
MAINTENANCE INSTRUCTIONS
1. Since fan bearings are sealed and provided with an internal lubricating
material, no additional lubrication is necessary.
2. It is recommended that the cover screen is checked on a regular basis to
check for any obstructions and the cover is removed and the motor and wheel
are inspected and cleaned as necessary.
No other maintenance is necessary.
3