Tamarack Technologies HV1450 EVERGREEN Product Manual & Installation Manual
WHOLE hoUSE COMFORT VENTILATOR
PRODUCT MANUAL & INSTALLATION GUIDE
HV1450 EVERGREEN
One (1) Whole House Comfort Ventilator
One (1) Damper
One (1) Metal electrical box cover with (2) screws
One (1) White Metal grille w/(6) screws
Four (4) Hex Standoffs
Four (4) Flat Washers
Four (4) Philips Head Screws
Four (4) Lock Nuts
Please note the serial number, date of purchase, and the
point of purchase below for handy reference. The serial
number is located on a label affixed to the HV1450 next
to the junction/utility box
.
When you have unpacked
your HV1450 carefully you will
find the following:
Unpacking your HV1450:
What the HV1450 Whole House Comfort Ventilator Does:
The HV1450 is used to assist the natural cooling process in the house. When the outside temperature drops below
the inside temperature, the cooler outside air can be used to cool the house. The HV1450 will pull the cooler air from
the outside, through the house, up into the attic and push the hot air outside. The HV1450 is a fan product and will
not cool the house below the outside air temperature or create a noticeable breeze. The HV1450 can be used any
time, for as long as needed, to cool or change the air in the house.
The Best Location for your HV1450:
The HV1450 should be located as central as possible to the area that
you want to cool. Above a central hallway or at the top of a stairwell provide the best airflow. Cooler outside air should be
able to move through the window, the space that needs to be cooled, and exhaust out through the fan into the attic.
►
Read all instructions before installing
►
Make sure that there aren’t any pipes, wires, rafters or air conditioning or heating ducts running through
the space where the HV1450 will be installed and that the damper will open into an unoccupied area.
►
Make sure that you have adequate exhaust area out of your attic. This can be accomplished with
a combination of roof, ridge or gable end vents. The HV1450 requires a minimum of 4 square feet of attic venting.
►
Some state and local electrical code require fan products to be installed by a licensed electrician.
Check with your local code officials before installation.
READ AND SAVE THESE INSTRUCTIONS
WARNING:
TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR INJURY TO PERSONS, OBSERVE THE FOLLOWING:
Use this unit in the manner intended by the manufacturer. If you have any questions, contact the manufacturer.
Before servicing or cleaning unit, switch power off at service panel and lock service panel to prevent power from being
switched on accidentally. When the service disconnecting cannot be locked, securely fasten a prominent warning
device, such as a tag, to the service panel.
When cutting or drilling into wall or ceiling, do not damage electrical wiring or other hidden utilities.
Never place a switch where it can be reached from a tub or shower.
Do not use this fan over a tub or shower.
Do not use this fan over cooking appliances.
WARNING:
To Reduce The Risk of Fire or Electric Shock, Do Not Use This Fan With Any Solid-State Speed Control Device.
CAUTION: For General Ventilation Use Only. Do Not Use To Exhaust Hazardous Or Explosive Materials And Vapors
CAUTION: This unit has an unguarded impeller. Do Not Use in Locations Readily Accessible to People or Animals.
Serial Number
Date of Purchase
Point of Purchase
320 Main Street • Buzzards Bay, Ma 02532
508-759-4660 / 800-222-5932 / Fax 508-759-6001