DL manuals
Tamron
Camera Lens
S
Product Support Bulletin

Tamron S Product Support Bulletin

Page of 15

Download

Print this page

Bookmark us

EPSON

Product Support Bulletin

Subject: Proper Method for Running Benchmark and Diagnostics Programs

Date: 06/04/93

PSB No: S-0158

Page(s): 1 of 1

Originator: MWT

This bulletin describes the proper method for running any benchmark or diagnostics

programs. This applies to any computer system.

In most cases, the computer should be started using an MS-DOS boot diskette

that’s ‘clean’ - in other words, one with no CONFIG.SYS or AUTOEXEC.BAT files.

The appropriate executable can then be run, either from diskette or hard drive.

There will be some exceptions to the above rule. In attempting to benchmark or

troubleshoot any add-on that requires a device driver (CD-ROM, local area network,

etc.), obviously the necessary device driver(s) must be loaded. Also, some

programs will require a minimum number of FILES or BUFFERS to be defined in

the CONFIG.SYS file. Such programs will usually display this requirement if they

are run without the necessary CONFIG.SYS file.

For the most consistent results, use the absolute minimal boot configuration that’s

allowed by the hardware being tested.

1 2 3 4 5 6 7 Next › »

Summary of S

Page 1
Epson product support bulletin subject: proper method for running benchmark and diagnostics programs date: 06/04/93 psb no: s-0158 page(s): 1 of 1 originator: mwt this bulletin describes the proper method for running any benchmark or diagnostics programs. This applies to any computer system. In most...
Page 2: Product Support Bulletin
Product support bulletin subject: equity/apex compatibility with the sota 386si date: 3/02/90 psb no: s-0111 page: 1 of 3 originator: the purpose of this bulletin is to provide the 80386 accelerator board test results, conducted by the computer product support center, involving the sota 386si from s...
Page 3
Psb no: s-0111 page: 2 of 3 installation of the board in most of the units was quick and simple to do when following the installation instructions accompanying the boards. Installation of the sota 386si in the equity i and the equity ii is rather difficult. Due to the amount of disassembly required,...
Page 4
Psb no: s-0111 page: 3 of 3 our computer product support center receives numerous calls requesting information and recommendations on 80386 accelerator boards for use with the equity and apex (8088- and 8086 - based) personal computers. We have found that the sota 386si may meet your requirements an...
Page 5: Product Support Bulletin
Product support bulletin subject: apex 100 computer - answers to common questions date: 9/5/89 page: 1 of 8 p s b n o : originator: q. Where can i obtain help regarding software or hardware questions on the apex 100 computer? A. Pfs first choice applications software software publishing corp. Provid...
Page 6
Psb no: s-0097 page: 2 of 8 q. What kind of printer can i use with the apex 100? A. The apex 100 includes an ibm pc - compatible parallel interface which is used to connect any printer or plotter with a standard parallel interface. An ibm pc- compatible parallel printer cable (not included) is requi...
Page 7
Psb no: s-0097 page: 3 of 8 q. Can a hardcard be installed in addition to a hard disk drive? A. Yes, but you must be sure that you do not mix mfm and rll type hard drives and you must be sure that the power supply is not overloaded by using low powered hard disk drives (less than 12 watts avg. Each)...
Page 8
Psb no: s-0097 page: 4 of 8 q. Can i add an external floppy disk drive to the apex 100? A. Epson does not currently manufacture an optional external floppy disk drive for the apex 100, however, the following companies manufacture external 3.5” and 5.25” floppy disk drives which are compatible with t...
Page 9
Psb no: s-0097 page: 5 of 8 q. Can i use the apex 100 monochrome monitor (model # ap - 1040) with other ibm pc - compatible computers? A. The apex 12” monochrome monitor (model ap - 1040) uses a ttl video signal which is ibm pc - compatible and can be used with other computers that have a monochrome...
Page 10
Psb no: s- 0097 page: 6 of 8 q. What kind of option cards are available for the apex 100 computer and where can i buy them? A. Most ibm pc/xt- compatible option boards will work in the apex 100 computer. You should visit a computer retail store to see a wide range of products. The products must stat...
Page 11
Q. A. Q. A. Q. A. Q. A. Q. A. Psb no: s-0097 page: 7 of 8 how do you connect two joysticks when there is only one joystick connector? A joystick adapter cable with 3 connectors is available from computer dealers which allows you to connect two joysticks into the single port. Will ibm compiled basic ...
Page 12
Psb no: s-0097 page: 8 of 8 q. Is the ibm 5250 emulation board compatible with the apex 100? A. Yes, the ibm 5250 emulation board (ver. 2.1) is certified with for use with the apex 100. Q. Can the apex 100 be used as a workstation on a local area network? A. The apex 100 has been tested as a worksta...
Page 13: Product Support Bulletin
Product support bulletin subject: equity and apex series compatibility with the system omnibridge controller and bridgefiler external floppy drives date: 04/11/90 page: 1 of 3 psb no: s-0088b originator: kas the purpose of this bulletin is to provide the results of compatibility testing conducted by...
Page 14
Psb no: s-0088b page: 2 of 3 equity ii + equity lie the equity ii + was found compatible with the omnibridge controller. It was able to support one or two external disk drives (daisychained) together. The external drives could be used as high density (1.2m and 1.44m) or normal (360k and 720k) disk d...
Page 15
Psb no: s-008b page: 3 of 3 apex 100 apex 200 the epson apex 100 was found compatible with the omnibridge controller. It was able to support one or two external disk drives (daisychained) together. The external drives could be used as high density (1.2m and 1.44m) or normal (360k and 720k) disk driv...