Owner’ owner’ owner’ owner’ owner’s man s man s man s man s manual ual ual ual ual model numbers: tbc-2211, tbc-2251,tbc-230/b tbc-2211, tbc-2251,tbc-230/b tbc-2211, tbc-2251,tbc-230/b tbc-2211, tbc-2251,tbc-230/b tbc-2211, tbc-2251,tbc-230/b trimmers/br trimmers/br trimmers/br trimmers/br trimmers/...
Www.Tanaka-usa.Com 1 custsvc@tanaka-ism.Com owner’s manual tbc-2211,tbc-2251,tbc-230/b before using this unit: • read the operator’s manual carefully. • check that the cutting equipment is correctly assembled and adjusted. • start the unit and check the carburetor adjustment. See “maintenance”. Warn...
Www.Tanaka-usa.Com 2 custsvc@tanaka-ism.Com owner’s manual tbc-2211,tbc-2251,tbc-230/b blade thrust may occur when the spinning blade contacts a solid object in the critical area. A dangerous reaction may occur causing the entire unit and operator to be thrust violently. This reaction is called blad...
Www.Tanaka-usa.Com 3 custsvc@tanaka-ism.Com owner’s manual tbc-2211,tbc-2251,tbc-230/b 1. What is what? Since this manual covers several models, there may be some difference between pictures and your unit. Use the instructions that apply to your unit. 1. Fuel cap 2. Throttle trigger 3. Starter handl...
Www.Tanaka-usa.Com 4 custsvc@tanaka-ism.Com owner’s manual tbc-2211,tbc-2251,tbc-230/b 2. Warnings and safety instructions. Operator safety • always wear a safety face shield or goggles. • always wear heavy, long pants, boots and gloves. Do not wear loose clothing, jewelry, short pants, sandals or g...
Www.Tanaka-usa.Com 5 custsvc@tanaka-ism.Com owner’s manual tbc-2211,tbc-2251,tbc-230/b 3. Assembly procedures drive shaft to engine (fig. 1 -1) loosen tube locking bolt (1) about ten turns so that the bolt tip will not obstruct drive shaft tube to be inserted. When inserting drive shaft tube, hold t...
Www.Tanaka-usa.Com 6 custsvc@tanaka-ism.Com owner’s manual tbc-2211,tbc-2251,tbc-230/b throttle wire/stop cord remove the air cleaner cover. (fig. 1-4) connect stop cords. (fig. 1 -5) set outer receiver (1) (if so provided) into wire guide and put throttle wire through the outer receiver. (fig. 1 -4...
Www.Tanaka-usa.Com 7 custsvc@tanaka-ism.Com owner’s manual tbc-2211,tbc-2251,tbc-230/b when using a trimmer head (2) with a two piece type blade guard, attach the guard extension to the blade guard. (fig. 1-9) then locate the guard above the gear case. (fig. 1-8b) note! If your unit has guard locati...
Www.Tanaka-usa.Com 8 custsvc@tanaka-ism.Com owner’s manual tbc-2211,tbc-2251,tbc-230/b 4. Operating procedures fuel (fig. 2-1) warning! The trimmer is equipped with a two-stroke engine. Always run the engine on fuel, which is mixed with oil. Provide good ventilation, when fueling or handling fuel. F...
Www.Tanaka-usa.Com 9 custsvc@tanaka-ism.Com owner’s manual tbc-2211,tbc-2251,tbc-230/b caution! Before starting, make sure the cutting attachment is not touching anything. Starting (fig. 2-2, 2b) 1. Set ignition switch (1) to the on position. (fig. 2-2) *push priming bulb (4) several times so that f...
Www.Tanaka-usa.Com 10 custsvc@tanaka-ism.Com owner’s manual tbc-2211,tbc-2251,tbc-230/b cutting (fig. 2-4, 4b, 4c, 4d) • when cutting, operate engine at over 6500 rpm. Extended use at a slow speeds may wear the clutch prematurely. • cut grass from right to left. • blade thrust may occur when the spi...
Www.Tanaka-usa.Com 11 custsvc@tanaka-ism.Com owner’s manual tbc-2211,tbc-2251,tbc-230/b 5. Maintenance maintenance, replacement, or repair of the emission control devices and systems may be performed by any nonroad engine repair establishment or individual. Carburetor adjustment (fig. 3-1) warning! ...
Www.Tanaka-usa.Com 12 custsvc@tanaka-ism.Com owner’s manual tbc-2211,tbc-2251,tbc-230/b note! If element is hard due to excessive dirt buildup, replace it. Drain all fuel from fuel tank and pull fuel filter line from tank. Pull filter element out of holder assembly and rinse element in warm water wi...
Www.Tanaka-usa.Com 13 custsvc@tanaka-ism.Com owner’s manual tbc-2211,tbc-2251,tbc-230/b flexible drive shaft (fig. 3-5) flexible drive shaft should be removed and lubricated with a good quality lithium grease every 20 hours. To remove the flexible shaft, first remove screw (1), loosen bolt (2) and r...
Www.Tanaka-usa.Com 14 custsvc@tanaka-ism.Com owner’s manual tbc-2211,tbc-2251,tbc-230/b maintenance schedule below you will find some general maintenance instructions. For further information please contact your tanaka service dealer. Daily maintenance • clean the exterior of the unit. • check that ...
Www.Tanaka-usa.Com 15 custsvc@tanaka-ism.Com owner’s manual tbc-2211,tbc-2251,tbc-230/b 6. Optional installation of free disk set (optional) (fig. 4-1, 1 b) 1) disassemble free disk (7) from the free disk set by loosening three bolts (8). 2) place blade (3) as shown in drawing. Disk fixing bolt (4) ...
Www.Tanaka-usa.Com 16 custsvc@tanaka-ism.Com owner’s manual tbc-2211,tbc-2251,tbc-230/b 7. Specifications note: sound levels are calculated as the time-weighted energy total under various working conditions with the following time distribution: ½ idling, ½ racing. All data subject to change without ...
Www.Tanaka-usa.Com 17 custsvc@tanaka-ism.Com owner’s manual tbc-2211,tbc-2251,tbc-230/b declaration of conformity d6claration de conformit6 dichiarazione di conformita konformitiitserkliirung declaraci6n de conformidad konformitetsdeklaration tanaka kogyo co., ltd., 3-4-29 tsudanuma, narashino, chib...
Www.Tanaka-usa.Com 18 custsvc@tanaka-ism.Com owner’s manual tbc-2211,tbc-2251,tbc-230/b important notice this information is for the us and canadian markets only. • to reduce the risk of injury from loss of control, never use a metal blade on a curved shaft grass trimmer. • never use a metal blade o...
Www.Tanaka-usa.Com 19 custsvc@tanaka-ism.Com owner’s manual tbc-2211,tbc-2251,tbc-230/b cutting attachments for tanaka trimmers and brushcutters 1) fixed line commercial cutting heads offer excellent durability and light weight. Great for commercial use. 2) tanaka brain fully automatic heads. The br...
