Owner’s manual model numbers: tps-2501,tps-2510 tps-250pf/pn,tps-270pf/pn polesaws p/n 28576 date 03-08-02 supplier to the outdoor power equipment industry ism, inc. • 1028 4 th street sw • auburn, wa 98001 • phone: (253) 333-1200 • fax: (253) 333-1212 www.Tanaka-usa.Com custsvc@tanaka-ism.Com tps-2...
Www.Tanaka-usa.Com 1 custsvc@tanaka-ism.Com owner’s manual tps-2501,tps-2510.Tps-250pn,tps-270pn before using this unit: • read the operator’s manual carefully. • check that the cutting equipment is correctly assembled and adjusted. • start the unit and check the carburetor adjustment. See “maintena...
Www.Tanaka-usa.Com 2 custsvc@tanaka-ism.Com owner’s manual tps-2501,tps-2510.Tps-250pn,tps-270pn.
Www.Tanaka-usa.Com 3 custsvc@tanaka-ism.Com owner’s manual tps-2501,tps-2510.Tps-250pn,tps-270pn 2. Warnings and safety instructions operator safety • always wear head protection with full face shield to help protect against falling branches and debris. • avoid all power lines. This unit is not insu...
Www.Tanaka-usa.Com 4 custsvc@tanaka-ism.Com owner’s manual tps-2501,tps-2510.Tps-250pn,tps-270pn 3. Assembly procedures drive shaft to engine (fig. 1 -1) loosen tube locking bolt (1) about ten turns so that the bolt point will not obstruct drive shaft tube to be inserted. When inserting drive shaft ...
Www.Tanaka-usa.Com 5 custsvc@tanaka-ism.Com owner’s manual tps-2501,tps-2510.Tps-250pn,tps-270pn warning! Never try to start engine without side case securely fastened. Note! When assembling brand new unit, take off and discard the cardboard (1) between gear case and side case. (fig. 1 -8a) installa...
Www.Tanaka-usa.Com 6 custsvc@tanaka-ism.Com owner’s manual tps-2501,tps-2510.Tps-250pn,tps-270pn 4. Operating procedures fuel (fig. 2-1) warning! The chainsaw is equipped with a two-stroke engine. Always run the engine on fuel, which is mixed with oil. Provide good ventilation, when fueling or handl...
Www.Tanaka-usa.Com 7 custsvc@tanaka-ism.Com owner’s manual tps-2501,tps-2510.Tps-250pn,tps-270pn adjustment of chain oil supply the chain oil quantity discharged through the lubrication system is factory-adjusted to the maximum. Adjust the quantity in accordance with the operating condition. • loose...
Www.Tanaka-usa.Com 8 custsvc@tanaka-ism.Com owner’s manual tps-2501,tps-2510.Tps-250pn,tps-270pn starting (fig. 2-5) caution! Before starting, make sure the cutting attachment does not touch anything. 1 . Set ignition switch (1) to on position. (fig. 2-5) *push priming bulb (4) several times so that...
Www.Tanaka-usa.Com 9 custsvc@tanaka-ism.Com owner’s manual tps-2501,tps-2510.Tps-250pn,tps-270pn safe operation • review the area to be trimmed. Look for hazards that could contribute to unsafe conditions. Do not operate unit if any wires(power, telephone, cable, etc.) are closer than 15m (50ft.) to...
Www.Tanaka-usa.Com 10 custsvc@tanaka-ism.Com owner’s manual tps-2501,tps-2510.Tps-250pn,tps-270pn 5. Maintenance maintenance, replacement, or repair of the emission control devices and systems may be performed by any nonroad engine repair establishment or individual. Carburetor adjustment (fig. 3-1)...
Www.Tanaka-usa.Com 11 custsvc@tanaka-ism.Com owner’s manual tps-2501,tps-2510.Tps-250pn,tps-270pn spark plug (fig. 3-3) the spark plug condition is influenced by: • an incorrect carburetor setting. • wrong fuel mixture (too much oil in the gasoline) • a dirty air filter. • hard running conditions (s...
Www.Tanaka-usa.Com 12 custsvc@tanaka-ism.Com owner’s manual tps-2501,tps-2510.Tps-250pn,tps-270pn side case (fig. 5-3) always keep the side case and drive area clean of saw dust and debris. Periodically apply oil or grease to this area to protect from corrosion as some trees contain high levels of a...
Www.Tanaka-usa.Com 13 custsvc@tanaka-ism.Com owner’s manual tps-2501,tps-2510.Tps-250pn,tps-270pn lowering depth gauges with a file 1) if you sharpen your cutters with a file holder, check and lower the depth. 2) check depth gauges every third sharpening. 3) place depth gauge tool on cutter. If dept...
Www.Tanaka-usa.Com 14 custsvc@tanaka-ism.Com owner’s manual tps-2501,tps-2510.Tps-250pn,tps-270pn maintenance schedule below you will find some general maintenance instructions. For further information please contact your service dealer. Daily maintenance • clean the exterior of the unit. • clean th...
Www.Tanaka-usa.Com 15 custsvc@tanaka-ism.Com owner’s manual tps-2501,tps-2510.Tps-250pn,tps-270pn note: sound level are calculated as the time-weighted energy total under various working conditions with the following time distribution: ½ idling, ½ racing. **all data subject to change without notice....
Www.Tanaka-usa.Com 16 custsvc@tanaka-ism.Com owner’s manual tps-2501,tps-2510.Tps-250pn,tps-270pn declaration of conformity tanaka kogyo co., ltd., 3-4-29 tsudanuma, narashino, chiba, japan tps-2501/2510 declare under our sole responsibility that the product, pole saw model tps-250pn,tps-270pn to wh...