TANDBERG 32" Flat Panel Display Package Installation Manual

Summary of 32" Flat Panel Display Package

  • Page 1

    D13803.06 page 1 installation set top bracket* unpacking the flat panel screen screw kit for table stand and different types of walls; gypsum/wood, concrete, brick wall mount rail wall brackets with velcro for monitor fixation, and cable strap. *if this flat panel display package has been purchased ...

  • Page 2

    D13803.06 page 2 installation monitor configuration connecting cables recommended maximum volume on the monitor is 65 out of 100. Source input: hdmi/dvi 32" flat panel display package dvi-d to hdmi cable audio cable pc stereo in bilde nr 6 hdmi audio (rgb/dvi) ac in.

  • Page 3

    D13803.06 page 3 wall mount 1. Lay the monitor on a clean surface, mount the speakers. Make sure the velcro strips are matched properly! 3. Bend the bracket into correct shape and fix onto the monitor. 4. Place set top onto bracket. Overhang of set top and bracket is needed for cable space towards w...

  • Page 4

    D13803.06 page 4 wall mount 6 a) wooden pillars (w/gypsum) 60 cm center-center. 6 b) wooden pillars (w/gypsum) 16 inch center-center. 6 c) brick/concrete wall. Mount into specified holes with screws only mount into specified holes with screws only 7 hook the system onto the wall mount rail. 8 fixate...

  • Page 5

    D13803.06 page 5 table stand 1. Place monitor onto table stand. 2. Secure the table stand with the six m4x10 secure the table stand with the six m4x10 screws into assigned holes. Make sure to screw all the way until tight! 3. Mount the speakers with the four screws attached. 4. Bend the bracket into...

  • Page 6

    D13803.06 page 6 table stand 5. Place set top onto bracket. Place bracket and set top along edge of monitor 6. Connect cables (see page 2) and fixate in cable straps. 7. This is not a floor-standing system. Place the system on a flat and rigid surface or table. 32" flat panel display package.