TANDBERG CSR820 Installation And Operation Manual - page 11
7
Quick Install and Setup Guide
This section outlines the minimum steps needed
to set up your CSR820.
Before starting the installation, take a moment to
review the front panel and menu operation
(pages 5-6).
•
If you will be receiving an encrypted signal, the
CSR820 must be authorized to receive this
signal and an authorized Smart Card must be
inserted. Contact your program provider for
authorization.
•
Make sure that the satellite antenna is
properly installed, and the LNB is operational.
Initial Setup
1. Connect the LNB input, audio, video, and
data. Select relay output per the rear panel
connection instructions (page 4).
2. Plug in the power cord. Verify that the
POWER LED is ON.
3. Observe the Self Test Screen and allow the
CSR820 to complete its self test (about 30
seconds). Once the Self Test is successfully
completed, the Default Screen will appear.
4. If the FAULT LED remains lit, contact
Tandberg Television Customer Service.
5. Press
MENU to display the Password screen.
6. Enter the default password or your own
password.
7. Press
ENTER to accept the password.
Acquire the Signal
1. Press
MENU to display the Receiver Setup
menu.
2. Press
OPTION to display the Frequency
submenu. Enter the L-Band Frequency.
3. Press
OPTION and enter the Symbol Rate.
4. Press
OPTION and enter the Viterbi Rate.
5. Press
OPTION and enter the LNB Polarity.
6. Press
OPTION and enter the Satellite Band.
7. Press
OPTION and set the LNB On or Off.
8. Press
ENTER to acquire the signal.
9. Verify that the ON LINE LED is lit.
Select a Video Mode (NTSC or PAL)
1. Press
MENU to display the IRD Setup menu.
2. Select
a
Video Mode. The selected mode
should be the same as the transmitted video
format.
3. Allow 30 seconds for the CSR820 to reboot.
Select a Service
1. Press
MENU to display the Service Setup
menu.
2. Select
a
Service from the ones that are
displayed.
3. Select
a
Video channel.
4. Select
an
Audio channel.
5. Verify that audio and video are present.