TANDBERG D5018501 Hardware User Manual

 1 

D5018501 

Installation of X-Port 10 with Director  

This document explains how to connect the X-Port 10 to the Director system. This feature allows easy 

connections for an external portable computer and automatic switching between the internal and external 

computer with the Director system. 

 Supplied Components: 

•  1 Connector Box 

•  1 RS232 Blanking Plate 

•  1 Pair of export 10 Mounting Bracket (Left and Right) 

•  2 T201-0036 Cables, 1 T201-0072 Cable, 1 T237-0072 Cable, 2 T112-0036 Cables, 1 T323-

0036 Cable, 1 T325-0072 Cable, 1 T324-0036 Cable, 1 T308-0036 Cable, 1 HD15D-Sub to 

BNC cable 

•  1 TANDBERG Director label 

•  4 #10-32 G-style panel nut retainer and 4 #10-32 x ¾” Black rack screw with washer 

•  10 Black adhesive cable tie mounting base14 cable ties 4” long 

•  2 #4-40 x 3/16” screws 

•  1 instruction sheet 

RS232 Blanking Plate Installation: 

Connector Box Installation: 

•  Install the blanking plate over the Computer 2 

Serial connector located on the rear of the 

Smart 3000i projector unit using the 2 supplied 

#4-40 x 1/8” screws. 

•  Install the connector box on the rear of the 

Smart 3000i as shown. 

•  Use the existing screws on the 3000i projector 

to fasten the connector box. 

•  Route the cables through the opening and 

connect them as per labels. (See System 

Connections)