Tandberg Data Storage Library T24 Installation Instructions Manual
Copyright 2006 Tandberg Data and Exabyte, EZ17, M2, VXA, and VXAtape are registered trademarks; ExaBotics, MammothTape, and SmartClean are
trademarks; SupportSuite is a service mark. Linear Tape-Open, LTO, the LTO Logo, Ultrium and the Ultrium Logo are trademarks of HP, IBM, and Quantum in
the US and other countries. All other product names are trademarks or registered trademarks of their respective owners.
433679-01
October 2006
www.tandberg.com
I
NSTALLING
THE
IN
A
R
ACK
Both the Tandberg StorageLibrary T24 and the Tandberg StorageLibrary T48 are designed
for installation in a standard 4-post, 19-inch rack.
The Tandberg StorageLibrary T24 uses 2 units (2U) of rack space
The Tandberg StorageLibrary T48 uses 4 units (4U) of rack space
The rack-mount kit includes the following items:
B
EFORE
Y
OU
B
EGIN
Select an appropriate location—The maximum recommended ambient temperature for
the library is 40° C (104° F). Install the library in an environment compatible with this
temperature limit. A ventilated rack is recommended.
Ensure that the work area is free from conditions that could cause electrostatic
discharge (ESD). Discharge static electricity from your body by touching a known
grounded surface, such as a computer’s metal chassis.
Ensure that the robot is “parked” and that the shipping key is in place prior to moving
the library. See the Product Manual at
www.tandberg.com
for instructions.
Obtain the following tools:
! Important
Two-post racks will not support either the Tandberg
StorageLibrary T24 or the Tandberg StorageLibrary T48.
18 – M5 x 12 Crest Cup™ screws (black) 2 – sets of side support rails
(left-side front and back rails and
right-side front and back rails)
2 – M3 x 8 Crest Cup screws (silver)
8 – washers
#2 Phillips screwdriver
Level
Tape measure