- DL manuals
- TANDBERG
- Server
- Management Server
- Quick Setup Manual
TANDBERG Management Server Quick Setup Manual
Summary of Management Server
Page 1
Management server quick setup guide d13939 rev 04 this document is not to be reproduced in whole or in part without permission in writing from:.
Page 2: Trademarks and Copyright
Tandberg management server quick setup guide ii trademarks and copyright all rights reserved. This document contains information that is proprietary to tandberg. No part of this publication may be reproduced, stored in a retrieval system, or transmitted, in any form, or by any means, electronically,...
Page 3: Environmental Issues
Quick setup guide iii environmental issues thank you for buying a product, which contributes to a reduction in pollution, and thereby helps save the environment. Our products reduce the need for travel and transport and thereby reduce pollution. Our products have either none or few consumable parts ...
Page 4: Operator Safety Summary
Tandberg management server quick setup guide iv operator safety summary for your protection, please read these safety instructions completely before operating the equipment and keep this manual for future reference. The information in this summary is intended for operators. Carefully observe all war...
Page 5
Quick setup guide v servicing - do not attempt to service the apparatus yourself as opening or removing covers may expose you to dangerous voltages or other hazards, and will void the warranty. Refer all servicing to qualified service personnel. damaged equipment - unplug the apparatus from the ...
Page 6: Contact Us
Tandberg management server quick setup guide vi contact us if you have any questions, comments or suggestions, please see the online support service at www.Tandberg.Com it is also possible to send a fax or mail to the attention of: product and sales support tandberg p.O. Box 92 1325 lysaker norway t...
Page 7: End-User License Information
Quick setup guide vii end-user license information important: the user manual cd for this product contains important terms and conditions including end user license agreements. The license agreements should be read prior to use. Use of this product constitutes acceptance of the terms of the licenses...
Page 8: Table of Contents
Tandberg management server quick setup guide viii table of contents 1 introduction ......................................................................................................................... 9 2 installation..................................................................................
Page 9: 1 Introduction
Quick setup guide introduction 9 1 introduction the tandberg management server is a server that comes with the tandberg management suite (tms) pre-installed. This guide will take you through the initial steps of setting up the tandberg management server before first time use. Please refer to the get...
Page 10: 2 Installation
Tandberg management server quick setup guide 10 2 installation precautions: never install communication wiring during a lightning storm. never install jacks for communication cables in wet locations unless the jack is specifically designed for wet locations. never touch uninstalled communicati...
Page 11: 2.1 Unpacking
Quick setup guide introduction 11 2.1 unpacking to avoid damage to the unit during transportation, the management server is delivered in a special shipping box, which should contain the following components: user manual and other documentation on cd. rack-ears, screws and screwdriver. cables: ...
Page 12: 2.2 Connecting Cables
Tandberg management server quick setup guide 12 2.2 connecting cables lan cable connect a lan cable from the ‘lan 1’ connector on the management server to your network. The lan 2, 3 and 4’ connectors are not used and should be left open. Power cable connect the system power cable to an electrical di...
Page 13
Quick setup guide introduction 13 2.3 ip address setting configuration the management server requires the ip address settings to be configured before it can be used. Ip address configuration can be made using the lcd panel. Front view of the management server with the lcd panel: lcd panel buttons an...
Page 14
Tandberg management server quick setup guide 14 5. Move between characters by using the up and down arrows. Edit values by pressing enter and using the up or down arrow to modify. Press enter again to confirm the value, or press return to restore the value to its previous state. 6. When finished edi...
Page 15: 3.1 Security Updates
Quick setup guide introduction 15 3 product registration and updates you need to register the product if you would like to receive an email from tandberg constant care services when management server updates to the tandberg management server become available. You can also check the following ftp sit...
Page 16: 4 General Use
Tandberg management server quick setup guide 16 4 general use tandberg management server the management server should always be turned on. The unit itself should not be available to users at any time. If the system does not respond: check the lcd panel to determine if the unit is switched on and ‘...
Page 17
Quick setup guide introduction 17 4.1.2 how to shutdown the management server 1. Press enter to display the main menu screen. 2. From the main menu screen, use the up or down arrow to select commands. 3. Press enter to confirm your selection. 4. From the commands menu, use the up or down arrow to se...
Page 19: 5 Administrator Settings
Introduction 19 5 administrator settings before the tandberg management server can be taken into use, some basic settings need to be configured. 5.1 operating system settings you can access the web user interface for microsoft windows server administration to configure operating system settings. 1. ...
Page 20: 5.2 Tandberg
Tandberg management server quick setup guide 20 to set the password of the local administrator account, click the set administrator password menu item under the welcome tab. From the maintenance tab, you can set the date, time and time-zone. 5.2 tandberg management suite settings you can access the ...
Page 21
Introduction 21 set the default time zone to where the majority of the tms users are situated to simplify user setup. Select the administrative tools > configuration > network settings menu item and scroll down to the tms services section to set the scan range tms uses to search for new systems. By ...
Page 22: 5.3 Added Systems
Tandberg management server quick setup guide 22 select the administrative tools > configuration > mail settings menu item to set the smtp server tms will use to send emails and the email address these will be sent from. 5.3 added systems the tandberg management server comes with automatic registrati...