1. DL manuals
  2. TANDBERG
  3. Switch
  4. RJ45RJ11
  5. Connecting

TANDBERG RJ45RJ11 Connecting

Summary of RJ45RJ11

  • Page 1

    116467.05 page 1 of 6 3 1 unpack the unit. 2 mount the rack ears and/or rubber feet and mount it in the rack, if applicable. Connecting the video switch put the video switch power supply here when rack mounting. Rubber feet (rubber pads) audio out data net pc card 1. Single 2. Single video out video...

  • Page 2

    116467.05 page 2 of 6 4 this diagram shows the additional connections needed to expand from using up to four tandberg precision hd cameras (see overleaf) to also include up to three tandberg wave ii cameras (i.E. Up to seven cameras in total). Connect video switch power supply as shown overleaf. 5 t...

  • Page 3

    116467.05 page 3 of 6 basic functionality physical inputs refer to explicit codec input and explicit switch input. These can only be controlled from the command interface. Xconfiguration mainvideosource, vidin and xconfiguration switch source always control the inputs directly. Example: to select ph...

  • Page 4

    116467.05 page 4 of 6 visca standard commands command set command packet comments cam_if_clear 8x 01 00 01 ff clear command buffer. Stop any current operation in progress. Cam_address_set 8x 30 0p ff p = address for this device. If x=8 (broadcast), increase p with 1 before sending to chain. Cam_comm...

  • Page 5

    116467.05 page 5 of 6 configuration commands messages starting with 8x-01-40- are configuration commands. Command command packet comments sw_port_0_cfg 8x 01 40 00 ... Ff currently not in use. Sw_port_1_cfg 8x 01 40 01 ... Ff currently not in use. Sw_port_2_cfg 8x 01 40 02 0p ff p=0: disable this po...

  • Page 6

    116467.05 page 6 of 6 a 㑻ໄᯢ ( a class product declaration) ᴀѻકЎ a 㑻 ite ˈ೼݊Փ⫼䇈ᯢ , 䫁⠠ㄝᰒ㨫ԡ㕂ЁᏆࣙ৿བϟݙ ᆍⱘໄᯢ (we declare here that the subject product is a class ite product, and the following statement is clearly marked in the user manual and nameplate ˖ ໄ ᯢ ℸЎ a 㑻ѻકˈ೼⫳⌏⦃๗Ёˈ䆹ѻકৃ㛑Ӯ䗴៤᮴㒓⬉ᑆᡄDŽ೼䖭 ⾡ᚙމϟˈৃ㛑䳔㽕⫼᠋ᇍ݊ᑆ...