TANDBERG VideoconferenceSystem Quick Start Manual - page 3
To start the unit:
Turn on the codec (videoconference unit) using the toggle switch on the back,
right hand side. A small light on the front of the camera will turn on, and the
camera will swivel as it resets itself. Turn on the monitor or smart board. The
Welcome Screen will appear.
If the unit is in standby mode (left on, but not used for a period of time) press any
key on the remote to wake it up.
Navigation Basics & Camera Control
Use the arrow keys on the front of the
remote are used to navigate through menus
as well as adjust camera settings.
To adjust the camera image, navigate to the
Camera Control Icon and select it.
Small arrows will appear on the screen. This
means that you can now control the camera
with your remote. Use the up, down, left and
right arrows to move the camera around the
room.
On the left side of the remote, use the zoom
feature to zoom in or out.