Tandem Buggy User Instructions - page 13
OCCUPIED TRANSPORT OF A TANDEM
BUGGY IN A SUITABLY MODIFIED VEHICLE
SECURING THE BUGGY TO THE TRACK SYSTEM IN THE VEHICLE FLOOR
The TANDEM BUGGY must be secured to the vehicle floor using a 4-point
webbing restraint system.
THE BUGGY MUST BE IN A FORWARD FACING POSITION
WITH THE REAR SIBLING SEAT REMOVED.
Wheel the buggy into position and apply the brakes.
The front of the buggy is secured first. Attach the front restraints to the track
system making sure that they are locked in position. Pass the webbing around
the tie-down point, which is clearly marked on the buggy chassis. Always
attach to the vertical section of the frame – the strongest part of the
construction.
Now that the front of the buggy has been secured, carefully move the buggy
backwards to take up the slack in the front restraints, and re-apply the brakes.
The rear restraints are attached to the clearly marked attachment point.
When the restraint is also attached to the track system in the vehicle floor,
use the ratchet to pull the restraint tight. Make sure that you have tensioned
the restraint on both sides of the buggy, and check that the buggy feels secure.
THE RESTRAINTS SHOULD BE ATTACHED AT AN ANGLE OF NO MORE
THAN 45 DEGREES TO THE VEHICLE FLOOR. IF YOU ARE IN ANY
DOUBT, CONTACT THE RESTRAINT MANUFACTURER FOR SPECIFIC
INSTRUCTION RELATING TO THEIR SYSTEM, OR YOUR DEALER FOR
QUERIES RELATING TO THE BUGGY.