- DL manuals
- Tando
- Recording Equipment
- TR-71S
- User Manual
Tando TR-71S User Manual
Summary of TR-71S
Page 1
User’s guide carefully read and fully understand instructions before using this unit. 2002.04 16004104060
Page 2
■ notices about this user’s guide ● carefully read and fully understand these instructions before using this unit. ● all rights of this user’s guide belong to t&d corporation. It is prohibited to use, duplicate and/or arrange a part or whole of this user’s guide without the permission of t&d corpora...
Page 3
It is dangerous to swallow batteries. Store all batteries, sensors and thermo recorder units out of the reach of children. If water or a foreign body enters the case, immediately cease using it. Continued use may cause fire, electrocution or damage. Make sure to use only power sources compatible wit...
Page 4
6 5 recorded data and recording settings will be lost if the batteries run out. It is recommended that the batteries be replaced before they run out. Battery life depends on the measurement environment, communication frequency, recording interval and battery quality. Approximate battery life of 1 ye...
Page 5
Introduction notices about this user’s guide ................................ 1 safety precautions and instructions .......................... 2 table of contents....................................................... 7 getting ready outline of the product...............................................
Page 6
■ front view sensor connection jack (channel 1) power switch built-in temperature sensor (channel 1) interval button (set recording interval) rec/stop button (start and stop recording) ■ right side view 9 part names and functions sensor connection jack (channel 2) available only for tr-71s communica...
Page 7
12 ① water leakage sensor seal normal (white) abnormal (red)） the seal turns red in an abnormal state. This indicates that the sensor has gotten wet. ② temperature sensor seal normal (white) abnormal (red) the seal turns red in an abnormal state and the figure 60 is displayed. This indicates that th...
Page 8
3 continuing to use the unit with the [bat] mark displayed and without changing the batteries will cause the display to change to [slp] and the unit will enter sleep. Please change the batteries immediately. ● recording stops and the recorded data and recording conditions are stored in the main unit...
Page 9
16 ⑦ ① ⑧ ① displays alternately channel number of present reading. ② displayed during recording; flashes when waiting to star t programmed recording. ③ indicates amount of data recorded. ④ indicates communication is occurring with computer. ⑤ indicates when measurement is above or below the limit. ▼...
Page 10
18 ■ set recording interval caution the recording interval cannot be set or changed during recording and /or during wait for a programmed start. 1 press down on the [interval] button for about 3 seconds or until the measurement value display changes to the recording interval display. Release the but...
Page 11
After reaching max ■ set up procedure 1 connect the serial port of your computer and the main unit through the standard communication cable. Connect the cable to a serial port which has the following mark: caution ● make sure to fully insert the connector to secure a proper connection. ● connecting ...
Page 12
22 collecting recorded data with our exclusive software "thermo recorder for windows" it is possible to download all of the recorded data from tr-71s and tr-72s as well as carry out the following functions in managing the data. - display 8 channels of data in colorful graphs - control display on / o...
Page 13
Tr-0706 stainless protection sensor cable length: 0.6m thermal-constant time in agitated water: approx. 18 sec. ※ only stainless section is water resistant. ■ wide range temperature sensors (for tr-71s) caution these sensors cannot be used with tr-72s/tr-71/tr-72. Possible measurement range: -60 to ...
Page 14
※ 1 there are 2 types of temperature sensors covering different ranges for use with the tr-71s. For details, see page 22 "optional sensors list". ※ 2 battery life differs depending on measurement environment and battery performance. Changing the battery is possible even during recording. Tr-71s tr-7...
Page 15
5652-169 sasaga matsumoto city nagano 399-0033 japan phone:+81-263-27-2131 facsimile:+81-263-26-4281 homepage:http://www.Tandd.Co.Jp/english/ e-mail:overseas@tandd.Co.Jp.