Summary of DAB-50
Page 1
Operation manual dab-50 dab/fm tuner.
Page 2
01 accessories accessories 1 x dab-50 1 x remote control 2 x batteries (optional) 1 x dab/fm antenna (optional) 1 x operation manual this operation manual supplies all the information that you need to have about your tangent dab-50. Please read this operation manual carefully before you start using ...
Page 3
02 contents accessories accessories 01 contents contents 02 safety precautions safety precautions 03 important safety instructions important safety instructions 04 important information important information 06 connection connection to the mains 07 remote control installation of batteries 08 using t...
Page 4
To minimise the risk of fire or electrical shock, do not expose the unit to rain or moisture. Do not open the cabinet as it contains dangerous voltage. Only qualified technicians are allowed to carry out repair and service. If the plug of the power cord needs to be replaced, it is important that the...
Page 5
Warning: it is important that you read and observe both the instructions in this manual and the instructions on the unit. Keep this manual for future reference. This unit was designed and manufactured with a view to providing maximum safety for the user. Incorrect use of the unit may cause electrica...
Page 6
Service do not attempt to carry out any service work yourself. By opening or removing the cabinet, you will be exposed to dangerous voltage or other hazards. Any service work should be carried out by qualified technicians. Spare parts if spare parts are required, make sure that the service technicia...
Page 7
Important information handling instructions the top and back panel of the unit may become warm after prolonged use. This is not due to a defect. Turn off the power when the unit is not used. Protect the power cord follow the instructions below to prevent abnormal operation, electrical shock, fire or...
Page 8
07 connection connection to the mains do not turn on the power before all connections have been made correctly. Check that all connections have been made correctly before turning on the power. Check that the mains voltage is 230-240v ac50hz before turning on the power. Connection to the mains check ...
Page 9
08 remote control installation of batteries remove the cover as illustrated. Position two batteries of the type aaa/r03/um4 in the battery compartment. Make sure that the orientation of the batteries is correct (see drawing at bottom). Replace the cover. Do not mix new and old batteries and do not u...
Page 10
09 some of the functions of the unit can only be performed by means of the remote control. Some functions are connected with the selected signal input source. Some buttons on the remote control may therefore not be available if the corresponding signal input source has not been selected. + + remote ...
Page 11
8 9 10 1 2 3 4 5 6 7 10 front panel and connections front panel mains switch: used to interrupt the mains voltage. Led indicator: lights green when the unit is turned on. Lights red when the unit is in standby mode or in operation. Preset no. 1: selects the station saved under no. 1. If the button i...
Page 12
11 front panel and connections connections 1 2 3 4 5 stereo output:: analogue stereo output. For connection to stereo amplifier or receiver with analogue input. Optical outputt: optical spdif output. For connection to stereo amplifier or receiver with digital input. Antenna a: for connection of the ...
Page 13
12 connection audio connection layout subwoofer (optional) phono tuner dvd cd aux 1 aux 2 function volume power headphone amp-50 amplifier analog amplifier/receiver phono tuner dvd cd aux 1 aux 2 function volume power headphone amp-50 amplifier digital amplifier/receiver item no.: 11048.01 power rat...
Page 14
13 optical output antenna contrast optical output antenna contrast for an optimal result it is recommended to install a dab antenna on the roof or on the loft. The supplied antenna must be adjusted for the best possible result by means of the signal bar described above. A good tip is to let the ante...
Page 15
14 phon power dab-50 dab/fm tuner 1 3 3 turn on the unit by pressing the mains switch. Press the standby button on the remote control to switch to standby mode. The display will turn off and all functions will be reduced to a minimum to make sure that the unit uses minimal power. When in standby mod...
Page 16
15 operation and functions dab tuning when the unit is turned on for the first time, all settings will be default settings. The settings can be changed according to your preference. When the unit is turned off the next time, these settings will naturally be saved as the new default settings. This al...
Page 17
16 operation and functions fm tuning the dab-50 offers both manual and automatic tuning on the fm band. This makes it possible to save just one specific channel. It also makes it possible to adjust the supplied antenna for the best possible signal. Dab/fm 4 3 2 1 autotune info control/tuning press t...
Page 18
17 troubleshooting troubleshooting problem cause/remedy no power when the unit is turned on. - switch on the electric current at the socket. - check that the plug has been correctly inserted into the socket. - the internal fuse has blown and must be replaced by a qualified service technician. - the ...
Page 19
18 technical data technical data rf section: tuner bands dab 174-240mhz (band iii) fm 87.5-108.0mhz sensitivity -96dbm type display:: 2 lines of 16 characters led backlight presets s 4 audio outputs s stereo, 2.5vpp 48khz sample rate 16 bit sample resolution optical spdif outputt iec60958 compliant ...
Page 20
Www. .Com tangent-audio.