Tangent T9i User Manual - page 3
Calibration
The touch display for the Tablet is calibrated before shipping. In the event that
the calibration has been modified or is unsatisfactory, the respective calibration
routines (e.g., PenMount (PM) to calibrate the touch interface may be used. Such
applications are typically executed through touch input via Stylus or through
mouse click via a USB mouse.
Button Management
Where supported by software, many of the hard buttons on the Tablet are
programmable to perform a function of the user’s choice. To activate the button
re‐assignment application, invoke the Button Manager application .
Wireless Networking
Wi‐Fi
The Tablet is often delivered with an embedded (user‐inaccessible)
802.11a/b/g/n Wi‐Fi adapter equipped with a hidden custom antenna.
Through the support of typical Wi‐Fi adapters, the Tablet should be able
to detect all 802.11 access points in the vicinity for you to select the
access point of your choice for connection.
The SSID and WEP/WPA/WPA2 (if enabled) parameters on the Tablet
and the access points have to match. The SSID is case‐sensitive and it is
recommended that you enable WEP/WPA/WPA2 encryption (or
advanced alternatives) for secure access.
When WEP/WPA/WPA2 is enabled, you may need to consult your
network administrator or your networking equipment literature to
properly configure associated settings such as Authentication mode,
etc.
Refer to the access point operating manuals for setting up the 802.11
access points.
Brightness Control
To control the screen brightness, launch the System Utility. The System screen will
display a Brightness control section with up and down arrows that can be activated
with the stylus.
Battery and Power Management
The Tablet is equipped with an internal Li‐Ion battery pack and an optional battery pack that
clips (hot‐pluggable) onto the back of the tablet. The period between battery recharges can
be significantly lengthened by putting the tablet into Standby mode through the Power
Button (see Buttons Function Table) whenever the tablet is not in use. Depending on the
operating software, the T9i may also be configured to enter various power‐saving modes via
the Power Button or through timed entry.
Peripherals Support
Through its USB port, the Tablet supports a wide range of USB‐based peripherals. These
peripherals are applicable for software installation, applications storage, data storage,
docking or software recovery and update.
The Tablet is complemented by an optional Desktop Cradle or Wall/ Vehicle Mount Cradle for
support, pass‐through charging, and connection to a range of USB peripherals, including
keyboard and mouse. The Cradles offer the following interfaces: a DC‐in port for the AC‐DC
adapter, an Ethernet port, video outputs and USB ports. Always seat the Tablet securely onto
the cradle. The cradle must be powered by the AC‐DC adapter for the Ethernet and USB ports
to function. The battery packs on the Tablet may be recharged by connecting the AC‐DC
adapter directly to the DC‐in port on the Tablet or through the DC‐in port on the Cradle while
the Tablet is docked.
Using T9i