Summary of TNR-50
Page 1
Tnr-50 fm/am tuner instruction manual.
Page 2
01 accessories accessories 1 x tnr-50 1 x remote control 2 x batteries (optional) 1 x fm antenna (optional) 1 x operation manual this operation manual supplies all the information that you need to have about your tangent tnr-50. Please read this operation manual carefully before you start using the ...
Page 3
02 contents accessories contents safety precautions important safety instructions important information connection remote control front panel and connections connection accessories 01 contents 02 safety precautions 03 important safety instructions 04 important information 06 connection to the mains ...
Page 4
To minimise the risk of fire or electrical shock, do not expose the unit to rain or moisture. Do not open the cabinet as it contains dangerous voltage. Only qualified technicians are allowed to carry out repair and service. If the plug of the power cord needs to be replaced, it is important that the...
Page 5
Warning: it is important that you read and observe both the instructions in this manual and the instructions on the unit. Keep this manual for future reference. This unit was designed and manufactured with a view to providing maximum safety for the user. Incorrect use of the unit may cause electrica...
Page 6
Service do not attempt to carry out any service work yourself. By opening or removing the cabinet, you will be exposed to dangerous voltage or other hazards. Any service work should be carried out by qualified technicians. Spare parts if spare parts are required, make sure that the service technicia...
Page 7
Important information handling instructions the top and back panel of the unit may become warm after prolonged use. This is not due to a defect. Turn off the power when the unit is not used. Protect the power cord follow the instructions below to prevent abnormal operation, electrical shock, fire or...
Page 8
07 connection connection to the mains do not turn on the power before all connections have been made correctly. Check that all connections have been made correctly before turning on the power. Check that the mains voltage is 230-240v ac50hz before turning on the power. Connection to the mains check ...
Page 9
08 remote control installation of batteries remove the cover as illustrated. Position two batteries of the type aaa/r03/um4 in the battery compartment. Make sure that the orientation of the batteries is correct (see drawing at bottom). Replace the cover. Do not mix new and old batteries and do not u...
Page 10
09 some of the functions of the unit can only be performed by means of the remote control. Some functions are connected with the selected signal input source. Some buttons on the remote control may therefore not be available if the corresponding signal input source has not been selected. Remote cont...
Page 11
8 9 10 1 2 3 4 5 6 7 10 front panel and connections front panel mains switch: led indicator: fm/am: autotune: memory: preset -: preset +: st/mono: reset: tuning: used to interrupt the mains voltage. Lights green when the unit is turned on. Lights red when the unit is in standby mode or in operation....
Page 12
11 front panel and connections connections 1 2 3 stereo output: antenna ac input analogue stereo output. For connection to stereo amplifier or receiver with analogue input. : for connection of fm or am antenna or for the communal antenna system. : for connection of mains voltage. Make sure that the ...
Page 13
12 connection audio connection layout fm antenna am tnr phono tuner dvd cd aux 1 aux 2 function volume power headphone amp-50 amplifier analog amplifier/receiver this page only contains suggestions for connection of your tangent tnr-50. Note that the accessories in the pictures on this page are not ...
Page 14
13 fm antenna am fm antenna am adjusting the antenna adjusting the antenna for an optimal result it is recommended to install a fm antenna on the roof or on the loft. The fm antenna must be adjusted for the best possible result. A good tip is to let the antenna end point in a vertical direction and ...
Page 15
14 + auto tune + tune preset memo fm am st/mo rds power tnr-50 phon power tnr-50 fm/am tuner 1 3 3 turn on the unit by pressing the mains switch. Press the standby button on the remote control to switch to standby mode. The display will turn off and all functions will be reduced to a minimum to make...
Page 16
15 operation and functions + auto tune + tune preset memo fm am st/mo rds power tnr-50 - preset + memory autotune fm/am st/mono reset tuning tuning 1 2 2 1 if you want to manual tune a channel, you must press the tune + or - button on the remote control, or turn the tuning knob on the front panel. F...
Page 17
16 operation and functions this tuner can be reset. This is used to delete channel stored in the unit. Press the reset button on the front panel to reset the unit. Reset stereo and mono selecting presets + auto tune + tune preset memo fm am st/mo rds power tnr-50 1 channels that have been saved can ...
Page 18
17 troubleshooting troubleshooting problem cause/remedy no power when the unit is turned on. - switch on the electric current at the socket. - check that the plug has been correctly inserted into the socket. - the internal fuse has blown and must be replaced by a qualified service technician. - the ...
Page 19
18 technical data technical data rf section: tuner bands fm 87.5-108.0mhz am 522-1620khz sensitivity -96dbm type 2 lines of 16 characters led backlight 40 stereo, 2.5vpp 48khz sample rate 16 bit sample resolution see back panel 430 x 290 x 75mm 4.5 kg display: presets audio outputs voltage and power...
Page 20
For further information please visit our website: www.Tangent-audio.Com item no. 40427 service hotline +45 9641 1599.