Tanita BD-815MA Instruction Manual - page 4
GB
GB
7
6
Safety Notes
(continued)
Please observe the following instructions for accurate measurement.
• Measurement may not be possible on a surface that is strongly vibrating. In such cases
transfer the equipment to a stable surface with little or no vibration.
• If the scale is moved, and the new location has a temperature difference of more than
+/- 20˚C please allow at least 2 hours for the temperature to adjust before using.
• While taking measurements, do not use mobile phones, microwave therapy equipment
or other types of transmitter near the scale as they may cause interference.
Temperature Range for Use : 5˚C - 35˚C
Relative Humidity
: 30% - 80% (without condensation)
Temperature Range of Environment : -10˚C - +50˚C
Range of Relative Humidity
: 10% - 90% (without condensation)
To avoid malfunctions, avoid storing the equipment where there is direct sunlight,
significant temperature changes, the risk of dampness, a large amount of dust, in
the vicinity of fires, or where there is the risk of receiving vibrations or shocks.
Instructions for Measurement
Explanation of terminology
• Max (Maximum Capacity)
This shows the maximum weight that can be measured by the scale.
[Example]
In the case of Maximum capacity 15kg, it can measure up to 15kg.
* One exceeding the weighing capacity cannot be measured.
• e (Minimum Graduation)
This shows the amount of one scale mark. In the case of a digital display, this shows the inter-
val of the numeric value to change.
[Example]
In the case of Minimum Graduation 2g (0 - 6kg) 5g (0 - 15kg) the display increases and decreases.
• Extend Minimum Graduation
This is the amount of the scale mark that can display more finely than the Minimum
Graduation.
The display range is up to 1g unit (this cannot be used for actions of transaction certification).
• Tare
The container, towel, blanket, etc., used when measuring weight is called “tare”.
To measure the net-weight after subtracting the weight of the tare is called "tare weighing."
Model
A30930G CLASS2 (centre minus)
Input Voltage
230VAC 50Hz 65mA
Output Voltage
9VDC ± 0.45VDC
Rated Current
300mA
No Load Voltage
12VDC ± 0.6VDC
Consumption Current
50mA
Power Consumption
0.5W max
Batteries (R6) 4
Consumption Current
40mA
Power Consumption
0.3W max
BD815MA̲GB
07.11.20, 11:34 AM
6-7