Tannoy AMS 5 Quick Start Manual - page 3
7. Connect the euro plug. If required, replace the
rubber grommet and fit snugly for a watertight seal.
8. Connect a secondary support line to the safety
tab at the rear of the cabinet.
5 Setting transformer taps
1. The rotary transformer tapping switch is found
on the top of models with 5-inch drivers, and
on the bottom of models with 6-inch and 8-inch
drivers.
CAUTION: The loudspeaker is supplied with the
tap switch set in low impedance mode. Never
connect the loudspeaker to a 70/100V amplifier
output while switched to low impedance mode.
2. Set the rotary switch to the appropriate position
for low impedance operation or for use in 70/100V
distributed systems. Models with 5-inch drivers are
fitted with 30W transformers; models with 6-inch
and 8-inch drivers are fitted with 60W transformers.
For more information on setting transformer taps
in distributed systems, please refer to the full AMS
Series Operation Manual.
6 Installation using the
optional accessory bracket
An optional accessory bracket is available that
allows flexible re-orientation of the loudspeaker
on the horizontal and vertical axes. Instructions
for installation and adjustment are included with
the bracket, and also are included in the full AMS
Series Operation Manual. Following installation, set
the transformer taps according to Section 5.