Summary of DANTE BRIDGE
Page 1
Dante bridge operation manual.
Page 2
2 dante bridge operation manual rev 2.1.0 important safety instructions please carefully read following instructions and safety information and retain for future reference. Heed all warnings and follow all instructions. • do not remove covers. There are no user-serviceable parts inside. Please refer...
Page 3
Dante bridge operation manual rev 2.1.0 3 table of contents table of contents 1. Thank you 4 2. Unpacking 4 3. Introduction / key features 4 4. Computer system requirements 5 5. Installation 5 6. External power supply 5 7. Connecting a computer 6 8. Podware setup 6 9. Connecting devices 7 10. Audio ...
Page 4
4 dante bridge operation manual rev 2.1.0 1. Thank you 1. Thank you thank you for choosing the dante bridge for your professional audio application. Please study the contents of this guide to obtain the best possible performance from this unit. 2. Unpacking after unpacking the unit, please check car...
Page 5
Dante bridge operation manual rev 2.1.0 5 4. Computer system requirements 4. Computer system requirements minimum requirements: • pc with >1 ghz processor • > 512 kb ram • 32-bit windows™ operating system (nt, 2000, xp, vista, windows 7) • cd-rom drive or internet access • ethernet connection 5. Ins...
Page 6
6 dante bridge operation manual rev 2.1.0 7. Connecting a computer 7. Connecting a computer you can connect your computer to the dante bridge in one of two ways: • by direct connection from the ethernet port of your computer to the dante bridge • by connecting your computer to an ethernet switch, an...
Page 7
Dante bridge operation manual rev 2.1.0 7 9. Connecting devices 9. Connecting devices • for analogue audio applications, simply connect one or both audio output xlrs to the analogue input(s) of the device. • for vnet devices, connect the vnet link socket on the dante bridge to the vnet in socket of ...
Page 8
8 dante bridge operation manual rev 2.1.0 10. Audio routing 10. Audio routing the dante bridge can use one or two audio channels from the dante stream. Normally the unit would be configured to route channels to input 1 and input 2. You may see an option to route to channels 3 and 4; however, these a...
Page 9
Dante bridge operation manual rev 2.1.0 9 12. Operation 5. Offer the accessory with its mounting brackets up to the reverse side of the mounting panel, and fix it in place using the two sets of screws, washers and nuts removed in 1. Dante bridge power net dante ext poe data sync data note that the h...
Page 10
10 dante bridge operation manual rev 2.1.0 13. Trouble shooting audio out 2 1 dante bvnet ext 1 2 3 4 5 the audio out 2 male xlr connector (1) carries the analogue audio signal for the second channel. The audio out 1 male xlr connector (2) carries the analogue audio signal for the first channel. The...
Page 11
Dante bridge operation manual rev 2.1.0 11 14. Technical specifications 14. Technical specifications ethernet compliance 100 base t or 1000 base t vnet cable type category 5 utp (or better) max. Total cable length 1 km max. Network span 1 km connector standard rj45 ext power only to be provided by a...
Page 12
Revision da te: 23 november 2015 tannoypro.Com tannoy operates a policy of continuous research and development. The introduction of new materials or manufacturing methods will always equal or exceed the published specifications. All specifications are subject to change without notice. Vnet and vnet2...