Tannoy HTS Owner's Manual - page 6
6 CONNECTING THE HTS SPEAKERS TO YOUR A/V RECEIVER OR AMPLIFER
Connect the speakers to the AV Home Cinema receiver or separate amplifier terminals as follows:
• Measure out suitable lengths of cable, to reach between the speakers and your AV or Home Cinema receiver speaker
output terminals.
• Wire up the system connecting each speaker to the appropriate terminals on the receiver or amplifier making quite
sure that cables connect red to red terminals (+ to +) and black to black terminals, (- to -). Take care to distinguish
between left and right channels, and the front and rear channels, as seen from the viewing position. This is a very
important stage in setting up. Getting things wrong at this stage is the most likely reason for disappointing results when
troubleshooting the system.
7 GRILLES
The HTS grilles have been designed to provide acoustic transparency. However, for ultimate fidelity the enthusiast will
appreciate the slight improvement in clarity and detail that is achieved by removing the grilles during listening.
8 CARE OF CABINET
The cabinets should only be cleaned with a dry cloth or with a light application of quality non-silicone furniture polish.
-
+
-
+
-
+
-
+
-
+
SUB OUT
FRONT
LEFT
REAR
LEFT
CENTRE
FRONT
RIGHT
REAR
RIGHT
AV RECEIVER/DECODER OUTPUT PANEL