Tannoy MERCURY V Owner's Manual - page 3
MERCURY V MANUAL_03
IntRoDUctIon
Thank you for selecting Tannoy loudspeakers, developed in the UK by our dedicated team of design engineers. They
are the choice of discriminating music lovers the world over. Musical excellence is designed into our loudspeakers from
the start. Careful selection of the very best components combined with strict quality control procedures in the production
process ensures this level of excellence is maintained.
To gain maximum performance from your loudspeakers, please take time to read this owner’s manual in full before
installation. once you have set up your new loudspeakers please register them on our website - this does not limit your
legal rights.
Loudspeakers are electromechanical devices that ‘run-in’ through use; performance will therefore improve after an initial
period of 24hrs use. once they have been further run-in over a longer period, there will be clear enhancement of the
stereo imaging, mid-band quality and bass performance characteristics.
we are confident that you will continue to enjoy your new Tannoy Revolution loudspeakers for many years to come.
AMPLIFIeRcHoIce
Consult the product specification pages within this manual as this clearly shows the acceptable power range for amplifier
matching to your speakers. The high peak power handling of Tannoy loudspeakers permits responsible use with more
powerful amplifiers - please read the warranty.
As with all loudspeaker systems, the power handling is a function of voice coil thermal capacity. Care should be taken
to avoid overdriving any amplifier, as this will cause output overload resulting in ‘clipping’ or distortion within the output
signal. This will cause damage to the speakers if done for any extended period.
Generally an amplifier of higher power that is running hard, but free of distortion, will do less damage to the loudspeaker
than a lower power amplifier continually clipping. Remember also that a high powered amplifier running at less than 90%
of output power generally sounds a great deal better than a lower powered example struggling to achieve 100%. An
amplifier with insufficient drive capability will not allow the full performance of the loudspeakers to be realised.
cABLecHoIce
Always use the best quality of cable available within your budget. High quality audio signals passing from the amplifier
to the loudspeaker are unusual in their demands on the cable. wide dynamic range and frequency bandwidth information
has to coexist with the ability to transmit peak currents of at least 10 amps, without incurring any loss or signal impairment.
This explains why the sound quality of the information reproduced by the loudspeakers is so dependant on the physical
properties of the cables connecting them to the amplifier.
we would recommend that you always keep the cable runs the same length for each speaker. Remember that cable
construction can affect the sound quality so be prepared to experiment to find a cable that suits your ear and audio system.
UnPAcKInG
To unpack the loudspeakers from their boxes remove tape from the top then fold the flaps right back before inverting the
carton and contents. Lift the carton clear of the contents then remove all inner packaging.
It is strongly recommended that you store all the packaging to allow protected transportation in future.
V4FLooRstAnDInGMoDeL
Mercury V floor-standing models perform best with carpet piercing spikes fitted. These are supplied, along with lock nuts,
and should be inserted into the threaded holes in the base of the cabinet. Level the speaker and then tighten the lock
nuts firmly but without using undue force. spike locating cups are provided in the accessory pack and these may be used
to protect sensitive floor surfaces.
WARnInG:
Ensure that the spikes are levelled and that the lock nuts are tightened firmly. The spikes should be pushed through the
carpet to locate into the flooring surface by applying pressure to the top of the cabinet.
If using on a sensitive floor surface place the protective cups under the levelled spikes. Failure to do so could render the
speaker unsteady and result in damage or injury should it be knocked over.