Summary of System 600
Page 1
System 600 user manual.
Page 2
Ntroduction thank you for purchasing the tannoy system 600 monitors. This loudspeaker is a very compact, professional near-field reference monitor. Using an advanced dual concentric 6.5” driver, if offers the advantages of the point source operation in a very cost-effective design. The attractive oc...
Page 3
Installing and connecting the loudspeakers. When choosing a suitable location for the monitors, bear in mind that the physical mounting of loudspeakers can have a large influence on performance. For best results the monitors should be mounted on a rigid structure, supported on four pads making conta...
Page 4
System description and philosophy a loudspeaker design naturally divides into various parts: cabinet, drive unit(s) and crossover. The design of these parts cannot take place in isolation as they are all interdependent. Drive unit. The drive unit used in the system 600 monitors is part of the latest...
Page 5
The emitted sound field, diffractions and reflections caused by the cabinet boundaries are too often overlooked although they are the cause of most of the irregularities heard and measured in the higher frequency areas. In that respect conventional rectangular, sharp corner boxes perform especially ...
Page 6
Servicing cabinet finish. To remove marks and scuffs use a medium soft brush. If necessary, a little warm water and detergent can be used but under no circumstances use a solvent or abrasive cleaner. The surface will change colour when wet but will return to normal when dry. For touch-up of paint ch...
Page 7
Checking the speaker at higher levels is permissible, provided that the lower frequency of the sweep is limited according to the voltage level ; for instance with levels exceeding 10v rms the frequency should be kept above 100 hz. List of spare parts. Part number description 9900 0258 system 600 cab...
Page 8
Curves figure 1. On axis anechoic response. Figure 2. Impedance.
Page 9
Technical specifications loudspeaker frequency response (1) 52 hz - 20 khz recommended amplifier power 50 to 150 w rms into 8 Ω power handling average (2) programme 80 w rms 160 w rms nominal impedance 8 Ω sensitivity (3) 90 db spl / 1 w @ 1 m distortion dispersion (@ -6db) 90 ° conical crossover fr...
Page 10
Declaration of conformity the following apparatus is/are manufactured in the united kingdom by tannoy ltd of rosehall industrial estate, coatbridge, scotland, ml5 4tf and conform(s) to the protection requirements of the european electromagnetic compatibility standards and directives relevant to dome...
Page 11
For tannoy ltd.
Page 12
Tannoy loudspeakers are manufactured in great britain by : tannoy ltd, rosehall industrial estate, coatbridge, strathclyde, ml5 4tf, scotland telephone: +44 (0)1236 420199 fax: +44 (0)1236 428230 internet:http://www.Tannoy.Com tannoy north america inc. 335 gage avenue, suite 1, kitchener, ontario, c...