1. DL manuals
  2. Tansun Quartzheat
  3. Heater
  4. Rio 010
  5. Reference Manual

Tansun Quartzheat Rio 010 Reference Manual

Summary of Rio 010

  • Page 1

    Spectrum house, unit 1, ridgacre road, west bromwich, west midlands, b71 1bw, england tel: +44 (0)121 580 6200 . Fax: +44 (0)121 580 6222 email: quartzinfo@tansun.Com . Website: www.Tansun.Com reference manual rio models 1.0kw / 1.5kw / 2.0kw horizontally mounted models 1.0kw / 1.5kw vertically moun...

  • Page 2

    Introduction the rio heater produces radiant heat like the sun, warming people and objects rather than the air in between. It is mounted on an adjustable bracket that allows the heat to be directed exactly where it is required. Its attractive, lightweight design means that it is effective yet unobtr...

  • Page 3

    Installation instructions the rio heater is fitted with a supply cable and a moulded plug, therefore the terminals should not be interfered with. The following points should be considered when positioning the heater: ● please observe the minimum safe distance between the heater body and any inflamma...

  • Page 4

    6. Gently pull the lamp wires through the body of the heater so the wires exit the terminal box (fig 5). 7. Staring at the left hand side, remove the end casing - this may require a few gentle taps to disengage the locating lugs and allow the casing to become free. The back plate will also now be fr...

  • Page 5

    11. Take your new lamp and refit by ensuring the leads pass down the sides of the lamp holders. The lamp can be clipped in by pulling the tabs back (fig. 11). 13. Turn the heater over and starting with one end of the heater, place one of the lamp leads into the back of the heater and shape it so it ...

  • Page 6

    17. From inside of the heater body, push one of the leads through the black rubber gasket and into the terminal box. The gasket has two small holes in it and one wire per hole should be inserted (the sleeving needs to be pulled back so only the white wire comes through) and push it firmly into eithe...

  • Page 7

    23. The heater can now be returned to its original mounting position and the mains power reconnected. Replacing the lamp - direct wired models 1. Ensure the heater and lamp are cool and the power supply is disconnected by removing the plug from the socket outlet. 2. Remove the heater from its mounti...

  • Page 8

    Spectrum house, unit 1, ridgacre road, west bromwich, west midlands, b71 1bw, england tel: +44 (0)121 580 6200 . Fax: +44 (0)121 580 6222 email: quartzinfo@tansun.Com . Website: www.Tansun.Com © tansun limited 2004. Part no. 042216. Issue 2 september 2006..