Tappan Millennia 316000182 Owner's Manual - Changing Oven Light

Manual is about: SEALED SURFACE BURNERS WITH SELF CLEANING OVEN AND ELECTRONIC OVEN CONTROL

Page of 20

Download

Print this page

Bookmark us

Changing Oven Light

(some models)

To Change the Oven Light (some models)

On some models, the oven light automatically turns on when the door is

opened. Some models have a switch located on the control panel to turn on

the light. The oven light is located at the rear of the oven and is covered with

a glass shield held by a wire holder. The glass shield must be in place whenever

the oven is in use.

To replace the oven light:

1. Turn electrical power off at the main source or unplug the range.

2. Press wire holder to one side to release the glass shield.

3. Replace bulb with a new 40 watt appliance bulb.

4. Replace glass shield over bulb and snap wire holder into place.

5. Turn power back on again at the main source (or plug the range back in).

6. The clock(if equipped) will then need to be reset. To reset, see Setting the

Clock and Minute Timer in this Owner's Guide.

Be sure the range is

unplugged and all parts are COOL before

replacing the oven light. Wear a leather-

faced glove for protection against

possible broken glass.

Note: The adjustments made will not

change the self-cleaning temperature.

Adjusting Oven

Temperature

The temperature in the oven has been set at the factory. When first using the

oven, be sure to follow recipe times and temperatures. If you think the oven

is too hot or too cool, the temperature in the oven can be adjusted. Before

adjusting, test a recipe by using a temperature setting that is higher or lower

than the recommended temperature. The baking results should help you to

decide how much of an adjustment is needed.

To Adjust Oven Temperature:

1. Push

2. Set the temperature to 550°F (287°C) by pushing and holding the

3. Within 2 seconds, push and hold

until the special 2 digit display

appears. Release

. The display now indicates the amount of degrees

offset between the original factory temperature setting and the current

temperature setting. If the oven control has the original factory calibration,

the display will read "00."

4. The temperature can now be adjusted up or down 35°F (17°C), in 5°F (1°C)

steps, by pushing and holding the

. Adjust until the desired

amount of offset appears in the display.

5. When you have made the desired adjustment, push

to go back to the

time of day display. When adjusting oven temperature, a minus sign (-) will

appear before the number to indicate that the oven will be cooler by the

displayed amount of degrees.

« ‹ Prev 14 15 16 17 18 19 20 Next › »

Summary of Millennia 316000182

Page 1
P/n 316000182 (9810) gas range sealed surface burners with self cleaning oven and electronic oven control owners guide read and save these instructions product registration .................................................. 2 important safety instructions ..................... 3-4 grounding instruc...
Page 2: Product Registration
2 thank you for choosing this appliance. The information contained within this owner's guide will instruct you on how to properly operate and care for your range. Please read through the information contained in your literature pack to learn more about your new appliance. Record your model and seria...
Page 3
3 remove all tape and packaging wrap before using the range. Destroy the carton and plastic bags after unpacking the range. Never allow children to play with packaging material. proper installationbe sure your appliance is properly installed and grounded by a qualified technician in accordance wi...
Page 4: Grounding Instructions
4 important safety instructions (continued) important instructions for using your cooktop know which knob controls each surface heating unit. Use proper flame sizeadjust flame size so it does not extend beyond the edge of the utensil. The use of undersized utensils will expose a portion of the bur...
Page 5: Control Pad Functions
5 control pad functions read the instructions carefully before using the oven. For satisfactory use of your oven, become familiar with the various functions of the oven as described below. Broil pad used to select the variable broil function. Up and down arrow pads used along with the function pad...
Page 6: Setting The Clock and
6 setting the clock and minute timer to set the clock when the range is first plugged in, or when the power supply to the range has been interrupted, the display will flash "12:00". 1. Push . 2. Within 5 seconds, push and hold the or until the correct time of day appears in the display. Note: the cl...
Page 7: Proper Burner
7 for most cooking, start on the highest control setting and then turn to a lower one to complete the process. Use the chart below as a guide for determining proper flame size for various types of cooking. The size and type of utensil used and the amount of food being cooked will influence the setti...
Page 8: Setting Warmer Drawer
8 warmer drawer recommended food settings chart food item setting roasts (beef, pork, lamb) med pork chops hi bacon hi hamburger patties hi poultry hi gravies med casseroles med eggs med fried foods hi vegetables med pizza hi biscuits med rolls, soft lo rolls, hard med pastries med empty dinner plat...
Page 9: Setting Oven Controls
9 setting oven controls to set or change the temperature for normal baking the oven can be programmed to bake at any temperature from 170°f to 550°f (65°c to 287°c). To set the controls for normal baking: 1. Push . " " appears in the display. 2. Within 5 seconds, push the or . The display will s...
Page 10: Setting Oven Controls
10 setting oven controls (continued) use caution when using the automatic timer. Use the automatic timer when cooking cured or frozen meats and most fruits and vegetables. Foods that can easily spoil such as milk, eggs, fish, meat or poultry, should be chilled in the refrigerator first. Even when ch...
Page 11: Setting Oven Controls
11 setting oven controls (continued) to broil 1. Arrange oven rack while oven is still cool. Position the rack as suggested in the chart below. Rack position from top food 1 rare steaks 2 ham slices, fish, medium steaks, hamburgers and chops 3 well-done foods such as chicken and lobster 2. Push . 3....
Page 12: Oven Cleaning
12 oven cleaning self-cleaning oven a self-cleaning oven cleans itself with high temperatures (well above cooking temperatures) which eliminate soil completely or reduce it to a fine powdered ash you can wipe away with a damp cloth. 1. Adhere to the following cleaning precautions: allow the oven to ...
Page 13: Oven Cleaning
13 oven cleaning (continued) to start the self-clean cycle *we recommend a 2 hour self-clean cycle for light soils and a 3 hour cycle for average to heavy soils (to assure satisfactory results). To set the controls for a self-clean cycle: 1. Be sure the clock shows the correct time of day. 2. Push ....
Page 14: General Cleaning
14 surfaces aluminum (trim pieces) & vinyl glass, painted and plastic body parts, control knobs and decorative trim pieces control panels porcelain enamel burner grates, cooktop surface, below cooktop, warmer drawer, door liner and oven bottom stainless steel, chrome parts, drip pans oven racks surf...
Page 15: General Cleaning
15 use caution when replacing the burner cap so the electrode is not damaged. This may cause a delayed ignition or prevent the burner from igniting. Any additions, changes or conversions required in order for this appliance to satisfactorily meet the application needs must be made by an authorized f...
Page 16: General Cleaning
16 general cleaning (continued) to remove and replace oven door to remove oven door: 1. Open the door. 2. Remove screws located on the inside of the oven door near the hinges a (one on each side.) 3. Close the door to the quarter-open position. Grasp the door firmly on both sides and lift up and off...
Page 17: Changing Oven Light
17 changing oven light (some models) to change the oven light (some models) on some models, the oven light automatically turns on when the door is opened. Some models have a switch located on the control panel to turn on the light. The oven light is located at the rear of the oven and is covered wit...
Page 18: Avoid Service Checklist
18 possible cause/solution poor installation. Place oven rack in center of oven. Place a level on the oven rack. Adjust leveling legs at base of range until the rack is level. When range is level, cooktop may appear out of alignment if countertop is not level. Weak, unstable floor. Be sure floor is ...
Page 19
19 in coastal areas, a slightly orange flame is unavoidable due to salt air. Be sure the electronic oven controls are set correctly for the desired function. See setting oven controls in this owner's guide or entire appliance does not operate (see below). Be sure regulator gas valve is "on". See ins...
Page 20: Tappan Range Warranty
Tappan, through its authorized servicers, will: pay all costs for repairing or replacing any parts of this appliance which prove to be defective in materials or workmanship. All of the provisions of the full warranty above and the exclusions listed below apply. The consumer will be responsible for: ...