Fcc id notice this device complies with part 15 of the fcc rules. Operation is subject to the following conditions: 1. This device may not cause harmful interference, and 2. This device must accept any interference received, including interference that may cause undesired operation. Caution: changes...
Al.1 install manual white: 16 awg positive park light output (+15amp) system chassis ground input red: 20 awg constant 12 volt input output to activate siren (+2amp) red/white: 22 awg output for trunk release (-) aux 1 output (-) starter disable (-) when armed dome light supervision white/green: 22 ...
Output to activate siren (+2amp) aux 1 output (-) starter disable (-) when armed dome light (-) when disarmed (30sec) wht/grn second unlock output (-) blue input for hood or trunk switch (-) green input for negative door pin switch purple input for positive door pin switch yellow switched ignition i...
Pin 1- brown wire- siren output (3amp maximum) connect this wire to the brown or red wire from the alarm siren. Pin 2- red/white wire- trunk release this output activates for 0.75 sec when the trunk button is held for 5 seconds. Pin 3- white/ blue wire- aux 1 (-250ma output) this output is activated...
3 pin keyless connector blue negative output for unlock red 12+ output for door lock module negative output for lock green system reset will set all program menu’s to the default factory setting. System reset cycle the ignition key - on/off on/off on (leaving the key on) 1 chirp confirms program mod...
3 pin keyless connector this connector is used when installing the optional keyless entry feature. If the door lock type of the vehicle is not negative you may need to install a voltage inverter, relays or a door lock module to install this feature. Pin 1- green wire- negative lock output connect to...
Setting # led/ siren 1 2 3 valet settings secure valet 15 seconds standard valet 8 seconds option 3 3 chirps option 1 1 chirp option 2 2 chirps park light output aux 1 output 30 second on for disarm 0.75 sec pulsed output n/a latched ignition on reset normal operation active while button held settin...
Transmitter programming entering remote program mode the system can lean up to 3 different transmitter codes. Each remote to be used must be programmed together during the same sequence. For security, when a new remote is programmed all previous remote’s are deleted. Please see remote operation char...
Shock sensor adjustments 3 chirps press and hold the lock and unlock buttons hold both buttons until the siren chirps to confirm the shock sensor setting. (1-10 chirps) note- if no buttons are pressed the shock sensor adjustment mode will automatically time out after 8 seconds. Each time the lock bu...
System programming - menu 1 install manual diagnostics al.1 alarm status / diagnostics alarm status / diagnostics led flashes output diagnostics 2 lock output overload 3 unlock output overload 4 trunk output overload 5 starter disable overload 6 not used 7 aux 5 output overload 8 2nd unlock output o...
