Targa LT 2210 User Manual And Service Information

Summary of LT 2210

  • Page 1

    Lt 2210 lcd- tv ready for you: www.Targa-online.Com user manual and service information gb ie 22 targa gmbh lange wende 41 d-59494 soest www.Targa-online.Com control panel 15 on/standby switch 16 programme down 17 programme up 18 show/hide tv menu 19 lower volume 20 raise volume 21 select source fro...

  • Page 2

    Lt 2210 lcd- tv ready for you: www.Targa-online.Com user manual and service information gb ie 22 targa gmbh lange wende 41 d-59494 soest www.Targa-online.Com control panel 15 on/standby switch 16 programme down 17 programme up 18 show/hide tv menu 19 lower volume 20 raise volume 21 select source fro...

  • Page 3

    Remote control 1 on/off button (standby) 2 numeric keypad 0…9 3 shift button for one/two-digit input 4 select audio channel 5 increase/decrease audio volume 6 four-way control 7 show/hide tv menu 8 picture preset selection 9 display programme information 10 pause button (teletext) 11 teletext on/off...

  • Page 4

    Targa visionary lt 2210 table of contents english - 1 table of contents introduction 3 safety instructions .................................................................................................3 positioning .....................................................................................

  • Page 5

    Table of contents targa visionary lt 2210 2 - english receiving tv programmes 14 automatic channel search ..................................................................................14 tv menu ........................................................................................................

  • Page 6

    Targa visionary lt 2210 introduction english - 3 introduction safety instructions please read the following instructions carefully. Please keep this user's guide for later use. If you sell the device or pass it on, it is essential you hand over this manual also. Follow all warnings. Proceed exactly ...

  • Page 7

    Introduction targa visionary lt 2210 4 - english separate the device from the mains during storms or when not using it for a long period of time, and also pull out the antenna plug. Always hold cables by the plug and never pull on the cable itself. Never hold the power cord with wet hands as this ma...

  • Page 8

    Targa visionary lt 2210 introduction english - 5 positioning do not place the device in direct sunlight. Avoid damp or dusty places. Place the device only on flat, vibration-free surfaces. Avoid positioning it in the vicinity of air-conditioning and heating units. Always make sure there is sufficien...

  • Page 9

    Introduction targa visionary lt 2210 6 - english intended use this device is a consumer electronics device. It may only be used for private use, not industrial or commercial. Furthermore, the device may not be used outdoors or in tropical climates. Only connection cables and external devices may be ...

  • Page 10

    Targa visionary lt 2210 getting started english - 7 getting started the lt 2210 offers multiple connection possibilities. These allow you to include the device more easily into any existing installation. The connection panel on the device’s back panel you’ll find the input connector panel. Depending...

  • Page 11

    Getting started targa visionary lt 2210 8 - english connecting the devices hdmi selected source: hdmi hdmi is the abbreviation for “high definition multimedia interface” and allows the digital transmission of both the audio and video signals. Use an hdmi cable (not included) to connect the output of...

  • Page 12

    Targa visionary lt 2210 getting started english - 9 s-video selected source: svideo to transmit video signals to other devices. Please note that the audio signal must be transmitted to the separate audio connector (10). Audio cable s-video cable component connector selected source: ypbpr use a tripl...

  • Page 13

    Getting started targa visionary lt 2210 10 - english scart (euro av) selected source: scart you can use a scart cable (not included) to connect other devices (e.G. A vcr or a dvd player) to the lt 2210. The device offers the two connectors scart1 (source: scart1) and scart2 (source: scart2 video). I...

  • Page 14

    Targa visionary lt 2210 getting started english - 11 inserting the batteries insert the supplied batteries (size aaa) into the remote control. Be sure to respect the polarity. The polarity is indicated with the symbols + and – on the batteries and in the battery compartment on the remote control. Re...

  • Page 15

    Getting started targa visionary lt 2210 12 - english the lt 2210 to standby mode and the power indicator (22) on the front panel will light orange. In order to also turn off the standby mode press the power button (1) on the back panel of the device. The power indicator will stop lighting. Selecting...

  • Page 16

    Targa visionary lt 2210 getting started english - 13 adjusting the volume you can adjust the volume of your lt 2210 either via the remote control or via the control panel. Press the vol+ button (5) on the remote control or the vol+ (20) button on the control panel of the lt 2210 to increase the volu...

  • Page 17

    Receiving tv programmes targa visionary lt 2210 14 - english receiving tv programmes the built-in receiver allows you to watch terrestrial tv shows via an outdoors or indoors antenna as well as tv shows from the cable tv network. To do so, connect the corresponding antenna cable to the rf input (see...

  • Page 18

    Targa visionary lt 2210 receiving tv programmes english - 15 tv menu the tv menu lets you perform specific settings to customise the lt 2210 according to technical and personal requirements. The menu is divided into five items allowing you to adjust or change picture, sound, source, system preferenc...

  • Page 19

    Receiving tv programmes targa visionary lt 2210 16 - english picture picture mode select one of the picture settings standard, dynamic or soft. Select “personal” to customize your settings. Contrast * to adjust the contrast. Brightness * to adjust the brightness. Hue * to adjust the colour hue/tint ...

  • Page 20

    Targa visionary lt 2210 receiving tv programmes english - 17 sound sound mode select between the default settings for standard, news, music and theatre. Select “personal” to customize your settings. Bass * increases or decreases the volume of the lower frequencies. Treble * increases or decreases th...

  • Page 21

    Receiving tv programmes targa visionary lt 2210 18 - english source tv input for receiving terrestrial tv broadcasts or cable tv. Switches the signal reception to the rf input (13). Scart1 first scart (euro av) connector. Switches the signal reception to the scart1 input (11). Scart2 video second sc...

  • Page 22

    Targa visionary lt 2210 receiving tv programmes english - 19 system osd language here you select the menus’ display language. Ttx language optimises the character set for western or eastern european, russian, arabic or farsi teletext. H-position moves the horizontal position of the osd menu. V-posit...

  • Page 23

    Receiving tv programmes targa visionary lt 2210 20 - english tv-channel color system select from the tv systems pal or secam according to the country you are located in. If you are not sure, please leave the automatic setting. However, make sure that the country selected under “program area” is corr...

  • Page 24

    Targa visionary lt 2210 receiving tv programmes english - 21 skip if you enable this function, empty preset channels will be skipped when switching channels up or down. Afc performs an automatic fine tuning of the frequency. Program area choose the country where you are using the device in order to ...

  • Page 25

    Receiving tv programmes targa visionary lt 2210 22 - english renaming a channel you can name a channel with any name containing up to five characters. Proceed as follows: press t or s (6) on the remote control to select the channel preset that stores the channel you want to rename. Press the red but...

  • Page 26

    Targa visionary lt 2210 advanced functions english - 23 advanced functions in tv mode, the device offers additional features to always guarantee a fast and trouble-free operation. These allow you to access directly to the most common options without having to navigate through different menus. Telete...

  • Page 27

    Advanced functions targa visionary lt 2210 24 - english sleep timer press the sleep button (23) to directly select the sleep timer. Press the sleep button multiple times to increase the remaining time in 15-minute increments. This lets you adjust the value from 15 to 60 minutes. The value 0 minutes ...

  • Page 28

    Targa visionary lt 2210 appendix english - 25 appendix pixel error classes pixels are single dots making up the picture that appears on the screen. One pixel always consists of three sub-pixels for displaying the basic colours (red, green and blue). The pixel error classes are rated from level i (ve...

  • Page 29

    Appendix targa visionary lt 2210 26 - english technical specifications screen size diagonal 22-inch (55.8cm) resolution 1680 x 1050 pixel brightness 300 cd/m 2 (typical) colours 16.7 million contrast 1000:1 (typical) response time 5 ms (typical) viewing angle 170° horizontal / 160° vertical (typical...

  • Page 30

    Remote control 1 on/off button (standby) 2 numeric keypad 0…9 3 shift button for one/two-digit input 4 select audio channel 5 increase/decrease audio volume 6 four-way control 7 show/hide tv menu 8 picture preset selection 9 display programme information 10 pause button (teletext) 11 teletext on/off...