English 3 table of contents preface 4 area of application of the target lasertrack 5 contents of the package and optional accessories 5 important information 6 installation 6 transponder alignment 7 calculation table for the installation of the transponder 8 testing the operation 9 important informa...
Preface you have just purchased a target lasertrack and are now the owner of a very advanced class 1 laser remote control system which can be used for various actions. The system is unique because it allows you to open your automated gate, garage door or turn on or off the outdoor lighting fully aut...
Area of application of the target lasertrack the target lasertrack is delivered in 3 packages: lt 400 vehicle system • 1 lt 400 car transponder (refer also to the accessories) • 1 led • 1 piezo signal device • 1 water leveller • all required connection and fastening material lt 430 house system • 1 ...
Accessories (optional) a special transponder for motorcycles is available. For motorcycles order the target lt400-m. The control elements of this set are completely waterproof and weatherproof. This system also has a special optical sig- nalling system that is always visible to the motorcyclist. Imp...
Cable connection: lt400 connect to: 1. Red switched 12 v from the vehicle (+15). This is the cable with 12 v as soon as the vehicle is started. Mount a fuse for this connection. A switch can be added to this connection if required. 2. Black earth. Connect this cable to a good earth source. Preferabl...
Calculation table for the installation of the transponder use the table below when mounting the transponder in the grill or behind a vent hole of the vehicle. Mounting the target lasertrack using the parameters below guar- antees maximum performance. English 8 measurements are in millimetres minimum...
Testing the operation the correct operation of the system can be tested after the target lt400 has been installed according to the instructions. 1. Switch the system on by starting the vehicle (if the switch has been added then it must be set to on). Result: the system emits a short audio signal and...
Faq about target lasertrack 1. Can other target lasertrack users gain access to my grounds or garage? No, target lasertrack has more than 4.5 thousand million unique codes. Only vehicles for which the code has been programmed in the basic transponder can gain access. 2. Does the target lasertrack la...
Installation of the lt425 control circuit board and the lt420 basic transponder mounting the lt420 basic transponder 1. The lt420 basic transponder is mounted in the same way as the lt400 car transponder. Ensure that the transponder is mounted at a location where it can detect the arriving vehicle. ...
Programming the target lasertrack 1. Park your vehicle at a few meters distance and in line with the basic transponder. Make sure that the lt400 is in stand-by mode. 2. Press the button-1 or button-2 button (depending on the group it is connected to) on the control circuit board for 2 seconds. Resul...
English 13 technical specifications lt400 type of emitter : indium gallium arsenide laser diode, class 1 type of receiver : infrared photodiode with optical and electronic amplifier wave length : 904 nanometre unique codes : > 4.500.000.000 measurements in millimetres : transponder 75 x 39 x 22 (l x...
Conditions of guarantee 1. The manufacturer guarantees the reliability of the system. The guarantee is valid for a term of 12 months for what concerns manufacturing and/or material failure and the following (excluding all other): - if and when the system is used for the purpose for which it was desi...
English 15.
English 16.
