Tascam CD-200i Owner's Manual

Other manuals for CD-200i: Owner's Manual

Summary of CD-200i

  • Page 1

    Cd-200i cd player/ipod dock d01086320b owner's manual.

  • Page 2: Important Safety Precautions

    Important safety precautions 2 tascam cd-200i the exclamation point within an equilateral triangle is intended to alert the user to the presence of important operating and maintenance (servicing) instructions in the literature accompanying the appliance. The lightning flash with arrowhead symbol, wi...

  • Page 3

    Important safety instructions tascam cd-200i 3 • do not expose this apparatus to drips or splashes. • do not place any objects filled with liquids, such as vases, on the apparatus. • do not install this apparatus in a confined space such as a book case or similar unit. • the apparatus draws nominal ...

  • Page 4: Safety Information

    4 tascam cd-200i ª cautions about laser radiation this product has been designed and manufactured according to fda regulations “title 21, cfr, chapter 1, subchapter j, based on the radiation control for health and safety act of 1968,” and is classified as a class 1 laser product. There is no hazardo...

  • Page 5: Safety Information

    Tascam cd-200i 5 safety information ª rack-mounting the unit if you are mounting the unit in a rack, leave 2u (10 cm) or more of space above it to prevent interference with devices installed above it and 4 inch (10 cm) or more of space at the rear. Use the rack-mounting kit to mount the unit in a st...

  • Page 6: Important Safety Precautions

    Important safety precautions 6 tascam cd-200i contents 1 − introduction .........................................7 main features .................................................. 7 included items ................................................. 7 about this manual ....................................

  • Page 7: 1 − Introduction

    Tascam cd-200i 7 1 − introduction thank you for your purchase of the tascam cd-200i cd player/ipod dock. Before connecting and using the unit, please take time to read this manual thoroughly to ensure you understand how to properly set up and connect the unit, as well as the operation of its many us...

  • Page 8: 1 − Introduction

    8 tascam cd-200i 1 − introduction trademarks • tascam is a registered trademark of teac corporation. • mpeg layer-3 audio coding technology licensed from fraunhofer iis and thomson. • "made for ipod" means that an electronic accessory has been designed to connect specifically to ipod and has been ce...

  • Page 9: Front Panel

    Tascam cd-200i 9 2 − names and functions of parts caution use the phones knob to minimize the volume before connecting headphones. Failure to do so could cause a sudden burst of loud noise, which might result in hearing damage, for example. 8 aux in jack this is a stereo mini-jack audio line input t...

  • Page 10

    10 tascam cd-200i 2 − names and functions of parts w display (shift) key (cd and ipod) when the output source is set to cd, press this key to change the type of time and text information shown on the display. When this key is pressed, the type of information currently displayed is shown for two seco...

  • Page 11: Rear Panel

    Tascam cd-200i 11 2 − names and functions of parts rear panel u analog output (unbalanced) jacks (cd, ipod and aux in) these jacks output analog signals (–10 dbv) of the cd or ipod playback sound signal or the signals input through the aux in jack. I digital output (coaxial) jack (cd) this jack outp...

  • Page 12: Display

    12 tascam cd-200i 2 − names and functions of parts 1 shuffle (cd and ipod) the shuffle indicator appears during shuffle playback mode. If the output source is an ipod, this indicator lights during song shuffle playback and blinks during album shuffle playback. 2 repeat, all (cd and ipod) repeat all ...

  • Page 13

    Tascam cd-200i 13 2 − names and functions of parts remote control unit (rc-cd200i) 1 numeric keys (cd) use the numeric keys to select tracks by their track numbers (see “selecting by track number” on page 23.) a track number can have a maximum of two digits for audio cds and a maximum of three digit...

  • Page 14

    14 tascam cd-200i 2 − names and functions of parts 7 folder ˙ / ¥ keys (cd and ipod) use these keys when the output source is set to cd and a data cd is loaded to change the playback folder. Select all to set the entire disc as the playback area. (see “folder playback (with data cds only)” on page 2...

  • Page 15: 3 − Preparation For Use

    Tascam cd-200i 15 3 − preparation for use digital in digital in analog in video in s-video in mixer, recorder, amplifier, or other device digital mixer, digital recorder, digital amplifier, or other device video equipment such as tv or monitor 3 − preparation for use before connecting other devices,...

  • Page 16: 3 − Preparation For Use

    16 tascam cd-200i 3 − preparation for use connecting an ipod with the ipod dock on the front panel allows the unit to output the sound of music and video playback from the ipod, as well as to control and recharge the ipod. Always attach a dock adapter suitable for your ipod to the connector. Dock ad...

  • Page 17: 3 − Preparation For Use

    Tascam cd-200i 17 3 − preparation for use opening the ipod dock press the center of the ipod dock, where it says “ push open ” to open the dock, and then pull it out. Pull the ipod dock completely out until it locks into place before using it locked position of dock after it is pulled out caution • ...

  • Page 18: 3 − Preparation For Use

    18 tascam cd-200i 3 − preparation for use by using the aux in input on the front panel of this unit to connect the analog outputs of other audio players and ipods that do not have dock connectors, you can transmit the output of these devices from the output jacks of this unit. Since the aux in does ...

  • Page 19: 3 − Preparation For Use

    Tascam cd-200i 19 3 − preparation for use preparing the remote control inserting batteries 1. Open the lid. 2. Confirm +/- polarity, and insert two aa batteries. 3. Close the lid. The batteries are not supplied for taiwan. Replacing the batteries replace both batteries with new ones when the range o...

  • Page 20: 3 − Preparation For Use

    20 tascam cd-200i 3 − preparation for use changing the output sound source for the audio signal output by this unit, the cd playback sound, the playback sound of the ipod connected to the ipod dock or the sound input through the aux in jack can be selected. Press the play mode/intro check (source se...

  • Page 21: 4 − Playing Back Cds

    Tascam cd-200i 21 4 − playing back cds discs that can be played this unit can play the following types of files and discs. ª cd-da (audio cd) format discs music cds that are commercially available and cd-r and cd-rw discs that have been recorded as audio cd format can be played. In this manual, thes...

  • Page 22: 4 − Playing Back Cds

    22 tascam cd-200i 4 − playing back cds loading a cd to load a cd, press the open/close key on the main unit or on the remote control to open the disc tray, and put the cd into the tray with the label facing up. Press the open/close key again to close the disc tray. After loading the disc, the unit r...

  • Page 23: 4 − Playing Back Cds

    Tascam cd-200i 23 4 − playing back cds selecting a track there are two ways to select a track. You can move (skip) to the previous or next track, or you can select a track directly by its track number. Skipping to the next or previous track press a search Ô / ( / ¯ ) key on the main unit or a search...

  • Page 24: 4 − Playing Back Cds

    24 tascam cd-200i 4 − playing back cds search forward and backward you can search forward and backward in a track while listening to it. 1 play or pause the desired track. 2 press and hold a search Ô / ( / ¯ ) key on the main unit or a search ( Ô / , ¯ / ) key on the remote control to start searchin...

  • Page 25: 4 − Playing Back Cds

    Tascam cd-200i 25 4 − playing back cds playback modes this unit can play tracks using three types of playback modes. Continuous playback (default setting) the tracks on a disc are played back in numerical order. In folder playback mode, the tracks in the current playback folder on a data cd are play...

  • Page 26: 4 − Playing Back Cds

    26 tascam cd-200i 4 − playing back cds • to select programmed playback, press the play mode/intro check (source sel) key on the main unit or the play mode key on the remote control when playback is stopped or no cd is loaded. • during folder playback, only tracks in the current folder can be include...

  • Page 27: 4 − Playing Back Cds

    Tascam cd-200i 27 4 − playing back cds • if you press the stop key when the empty program step where it is possible to add a track appears, all steps in the program are cleared. • if you try to add more than 99 tracks, a “pgm full” error message appears. Only 99 tracks can be added. Checking the pro...

  • Page 28: 4 − Playing Back Cds

    28 tascam cd-200i 4 − playing back cds repeat playback you can play a selected track or all tracks repeatedly. Press the repeat (pitch on/off) key on the main unit or the repeat key on the remote control to select from one of the following repeat modes. Repeat (pitch on/off) key repeat (pitch on/off...

  • Page 29: 4 − Playing Back Cds

    Tascam cd-200i 29 4 − playing back cds audio cds with cd text when stopped, the display cycles through total time, album title and album artist. When playing back or paused, the display cycles through track elapsed time, track remaining time, total remaining time, track title and track artist. Audio...

  • Page 30: 4 − Playing Back Cds

    30 tascam cd-200i 4 − playing back cds caution • during playback, turning pitch control playback on or off might cause the playback sound to skip momentarily. • using pitch control playback with a data cd (mp3, wav) sometimes causes the playback sound to skip. • digital output is possible when the p...

  • Page 31: Ipod Dock

    Tascam cd-200i 31 by connecting an ipod with the ipod dock on the front panel, this unit can control the ipod and output its sound/ video. Moreover, it can also recharge the ipod when this unit’s power is on. Ipod dock connect an ipod following the instructions on page 16. Always attach a dock adapt...

  • Page 32: Operation Messages

    32 tascam cd-200i operation messages the following messages are shown on the main display according to the operation of the cd player. Message message lit or blinking meaning response -clear- lit all programs have been cleared. Close lit the disc tray is closing. No disc lit there is no disc or the ...

  • Page 33: 7 − Troubleshooting

    Tascam cd-200i 33 if you have problems with your system, look through this chart and see if you can solve the problem yourself before calling your dealer or teac service center. ª no power e is the unit’s power plug completely inserted into a working power outlet? ª remote control doesn’t work. E ch...

  • Page 34: Backup Memory

    34 tascam cd-200i ª digital output (coaxial) terminal connector: rca pin jack compatible signal format: iec-60958 type ii (s/pdif) ª video output connector: rca pin jack compatible signal format: composite video signal output impedance: 75Ω ª s-video output connector: 4-pin mini-din connector compat...

  • Page 35: General

    Tascam cd-200i 35 general ª power requirement ac 120 v, 60 hz (u.S.A./canada) ac 230 v, 50 hz (u.K./europe) ac 240 v, 50 hz (australia) ª power consumption 12 w ª dimensions (w x h x d) 481 x 94.5 x 298 (mm) / 18.94 x 3.72 x 11.73 (in) ª weight 4.7 kg (10.36 lb) ª operating temperature 5 to 35°c ª i...

  • Page 36: Cd-200I

    Cd-200i teac corporation http://tascam.Jp/ phone: +81-42-356-9143 1-47 ochiai, tama-shi, tokyo 206-8530, japan teac america, inc. Http://tascam.Com/ phone: +1-323-726-0303 7733 telegraph road, montebello, california 90640 usa teac mexico, s.A. De c.V. Http://teacmexico.Net/ phone: +52-55-5010-6000 r...