Tascam CD-VT2 Owner's Manual - Important Safety Precautions

1

TASCAM  CD-VT2

IMPORTANT SAFETY PRECAUTIONS

Quick Start Guide—Basic Operation

Using the Effects 

To apply effects to the signal input through the mic, press the 

EFFECT

 key to open the 

EFFECTOR

 screen. When the 

BANK

value is highlighted as shown below, use the 

VALUE (+, –) 

keys 

to select one of the effect banks (01–05). 

After selecting an effect bank, select an effect preset by using 

the down 

CURSOR

 (

¶

) key to highlight the 

PRESET

 value. 

Then use the 

VALUE

(+, –)

 keys to select a preset. Each preset 

uses a different combination of effect modules. (See the 

“Effect preset list” on page 39.) 

Press the right 

CURSOR

 key (

¥

) to open the effect level 

adjustment screen. Use the 

VALUE

(+, –)

 keys to change the 

level. 

NOTE

You can change the parameter settings for every effect. 

(For details, see “Using built-in effects” on page 31.) 

Singing or playing along with a CD

You can listen to the sound from both a CD and your voice or 

instrument at the same time through headphones. To change 

the volume balance between the CD and the mic input, press 

the 

LEVEL

 key to open the 

LEVEL

 screen. Press the right 

CURSOR

 key (

¥

) to highlight the

 MIC 1 LEVEL

 value, 

then use the 

VALUE

(+, –)

 keys to adjust the mic volume. (See 

“Adjusting the input level” on page 30) 

Turning off the power 

When you stop using the player, press the 

POWER

 switch on 

the back of the unit for about one second. Release the switch 

when “

TRAINER SERIES

” appears on the display. 

Restoring all settings to original values

If you press and hold both the 

µ

 and 

≤

 keys when you turn 

the player power ON, the 

INITIALIZE

 screen appears. 

After startup, follow the onscreen instructions and press the 

¥/π

key

 to restore every effect parameter, playback setting 

and other adjustable setting to the values they were set at when 

they unit was shipped from the factory.