Tascam DA-88 Setup Manual - page 5
Spirit Digital 328 v2
4
In a configuration using one or two DTRS machines, the 328 must be made to be the Wordclock
Master device. Enter the 328 Menu pages by pressing the button on the right hand
side of the LCD display. Using the encoder beneath the display, scroll up or down until the ‘Clock
Source Sel’ menu is highlighted, and press
can be toggled between 44.1kHz and 48kHz, depending on which is required. Use the encoder
to toggle the clock rate, press
menu pages.
To ensure that the Digital 328 Tape Port A is set to TDIF, enter the 328 Menu pages by pressing
the button on the right hand side of the LCD display. Using the encoder beneath the
display, scroll up or down until the ‘Tape Port Select’ menu is highlighted. Press
keep pressing the Up cursor arrow until the ‘
the encoder, set the Bank Source to TDIF. Press the Down cursor arrow once, to set the
wordlength. The Wordlength required for all DA machines is 16 bit. The wordlength is set on
the 328 with the encoder. Press
the menu pages.
To configure the 328 to send the MMC controls to the DTRS and vice versa, the DTRS option
must be selected in the Tape Machine Setup menu. Enter the Menu pages by pressing the
button, and scroll up or down with the encoder until the ‘Tape Mach Setup’ menu is
highlighted. Press
again.
Internal:44.1kHz
Internal:48.0kHz
Bank Source:TDIF
or
Wordlength: 16
2
Digital 328 Setup
Digital 328 Setup
Digital 328 Setup
Digital 328 Setup
Wordclock
Wordclock
Wordclock
Wordclock
Tape Ports
Tape Ports
Tape Ports
Tape Ports
MIDI
MIDI
MIDI
MIDI