Tascam DM-24 Features Manual

 TASCAM DM-24 Version 2.1 Release Notes 

1

New features in DM-24 version 2.1

Buss assignment

Busses 1-8 can now be assigned to the stereo buss on 

the 

ASSIGN

 page, the 

MODULE

 page and also using the 

ASSIGN

 section key. 

Bear in mind that like 

EFFECT 1-2

, 

DIGITAL IN 1-2

 and 

ASSN RETURNS 1-4

, these signals enter the stereo buss 

after (post) the Master Comp Insert Matrix. 

The result of this is that if you are compressing the 

stereo buss, these signals assigned to the stereo buss 

are not affected by the compressor. 

However, if the 

ASSIGNABLE

 sends and returns are 

used as stereo buss 

INSERTS

, these inserts will affect 

the signals sent to the stereo buss. Any analog inserts 

used on the stereo buss will also affect these signals.

1

To assign these signals directly to the stereo 

buss, use POD 4 to move the cursor to 

ST

 in 

the upper right of the 

ASSIGN

 page. 

2

Then use the 

SEL

 key of the buss, or the cur-

sor keys or the dial to highlight the item you 

wish to assign and press the 

ENTER

 key.

This assignment can also be made in the buss 

MODULE

 page.

To assign busses 1-8 to the stereo buss using the 

STEREO

 key in assign section:

1

Select the busses 1-8 using the 

SEL

 keys.

2

Then press the 

STEREO

 key in the assign sec-

tion. Busses 1-8 are assigned to the stereo 

buss directly (this can be confirmed on the 

MODULE

 page).

Buss signals assigned to the stereo buss fol-

low the 

Balance Level CENTER: 0dB 

setting on the 

OPTION-PREFERENCES

 page.

9101449300