Summary of 119203C
Page 1
Instruction manual digital trail camera model#: 119203c lit #: 98-1164/03-10
Page 2
2 congratulations on your purchase of the tasco ® digital trail camera! This weatherproof, rugged trail camera is designed to record still images or movie clips of outdoor wildlife activity. This instruction manual will help you understand, setup, and use your cam to achieve the best possible result...
Page 3
3 quick guide: tasco trail camera 1. Open the camera by releasing the latches on the right side of the camera. Install 4 “d” cell batteries (flat base of all batteries contacting springs), and insert an sd card (not included, use any capacity up to 2gb) in the slot to the right of the 5 buttons (ups...
Page 4
4 digital trail cam specifications lens f/3.5, effective focal length 42mm. Sight range: 45 degrees flash high power electronic xenon flash. Range: 30 ft. Pir sensor low noise, high sensitivity passive infrared sensor. Range: 30 ft. Motion led indicator yes display monochrome lcd. Auto-off: 3 min. 2...
Page 5
5 glossary pir—passive infrared sensor. Senses motion like typical security motion detector. Requires infrared energy (heat) in addition to motion to trip sensor to assure detection of live animals. Image—a digital picture recorded on the sd card when motion is sensed. Images are taken at the desire...
Page 6: Parts
6 parts guide front of camera button & display detail control panel inside front sd card slot lcd display setup, menu & power buttons pir pir detected (or low battery) led lock tab camera lens flash.
Page 7: Setup and Operation Guide
7 setup and operation guide 1. Open the cam by pulling out on the two latches on the right side. Install 4 “d” cell batteries (flat base of all batteries contacting springs), and insert an sd card (not included, use any capacity from 16mb to 8gb. Do not substitute mmc cards.) in the slot to the righ...
Page 8
8 resolution images of better quality but fewer images can be stored to the card. In movie mode a 14 second avi file will be recorded to the sd card each time the camera is triggered. 4. Pressing enter again after the resolution options will go to the format screen next. Formatting is recommended be...
Page 9
9 setup guide (cont.) by “snap”, then “slp” (sleep). Note: for movie clips, the display will stay on “snap” for the 14 sec duration of each movie. 7. Thread the strap through the slots on the back of the cam and attach the buckles, then strap it onto a suitable tree, making sure the strap is tight a...
Page 10
10 about the pir sensor the sensor that triggers the trail camera is passive infra red, or pir. Infrared energy is essentially heat energy. The pir detector operates by sensing a change in the infrared level in its detection zone. This zone is a cone in the center 30 degrees of the camera’s field of...
Page 11
Fcc note: this equipment has been tested and found to comply with the limits for a class b digital device, pursuant to part 15 of the fcc rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and c...
Page 12
©2010 b.O.P. For further questions or additional information please contact: tasco 9200 cody, overland park, kansas 66214 (800) 423-3537 • www.Tasco.Com.