1. DL manuals
  2. Task Force
  3. Lawn Mower
  4. 26133
  5. Operator's Manual

Task Force 26133 Operator's Manual

Manual is about: 16 in. REEL MOWER

Summary of 26133

  • Page 1

    Tm read your operator’s manual completely and carefully before attempting to set up or operate your new reel mower. All operators of this equipment should read and understand all safety rules printed on the machine and in this operator’s manual before use. Caution - for your safety notice: on the na...

  • Page 2

    Table of contents ………………………………………………………………………………….…………..…………………3 ………………………………………………………………………….…………..…………………2 2 product specifications product specifications safety information ………………………………………………………………………….…………..……………….4/5 assembly instructions cutting height adjustment blade adjustment …………………………………...

  • Page 3

    Never place hands, fingers or feet inside the reel. Although a motor does not power this mower, when the wheels turn the reel spins and can cut. Never mow when grass is wet as it can be slippery. Do not use the reel mower while barefoot or while wearing sandals. Walk behind, never run, while using r...

  • Page 4

    4 assembly instructions 1. Top handle 2. Center handle pieces 3. Left lower handle 4. Right lower handle 5. Foam grip 6. 1- 3/8 in. Bolts 7. Flat washer 8. Wing nut tools required pliers (not included) fig. 1 assembling the handle: (fig.1) note: do not completely tighten bolts until assembly is comp...

  • Page 5: Fig. 2

    Attaching the handle to the mower base: (fig.2) 1. Align holes (1) at the lower end of each handle arm with short posts (2) extending from the mower base side plates. Slide lower ends of handle arms onto posts. 5 fig. 2 1 2 2. After handle arm holes are on posts, use pliers to snap c-clips (1) onto ...

  • Page 6

    Cutting height adjustment: (fig. 3) operation 6 fig. 3 height adjustment nut 1. The cutting height of the 16 in. Reel mower can be adjusted from 5/8 – 1-7/8 in. Using the roller assembly. 2. For the lowest cutting position, loosen and remove the adjust ment nuts on both sides of roller assembly. Pos...

  • Page 7

    Mower blade adjustment: (fig. 4) warning: blades are extremely sharp. To avoid injury, do not touch blades when making adjustment. Note: blades are factory adjusted. Caution: Αdjusting the screws for blade adjustments is a very sensitive procedure. A turn of 1/16 is considered a major adjustment. Βe...

  • Page 8

    Two-year limited warranty the manufacturer warranties that this product is free from defects in material and workmanship for two (2) years from the date of the original purchase by the original purchaser only. This warranty is not transferable and does not cover: products sold damaged or incomplete,...

  • Page 9

    Parts diagram 9.

  • Page 10

    Parts diagram list item description qty 1 housing 1 2 reel blades 1 3 top push handle 1 4 center handle pieces 2 5 lower handle 2 6 spring 2 7 spring washer 2 8 bearing 2 9 wheel cover 2 10 gear wheel 2 11 pin 2 12 shaft 1 13 foam grip 1 14 washer 2 15 bolt 2 16 wheel 2 17 cutting bar adjustment lev...