Questions, problems, missing parts? Before returning to your retailer, please contact our customer service department at 1-866-788-5598. Item / articulo # 0008885 model / modelo # tf2000 2000psi electric pressure washer español p. 19 this product is covered by us patents and other international pate...
Warning: carefully read this operator’s manual before starting up the washer for the first time. Caution: always store your pressure washer in a location where the temperature will not fall below 40°f. Freeze damage is not covered by the warranty. 2 table of contents product specifications safety in...
Warning: this warning symbol identifies specific instructions or procedures which if not correctly followed could result in personal injury or death. Caution: this caution symbol identifies specific instructions or procedures which, if not strictly observed, could result in damage to, or destruction...
Warning: risk of injection or injury - do not direct discharge stream at persons. Safety information 4 15. Check power cords before using. Damaged cords can reduce performance of pressure washer or cause a fatal electric shock. 16. The narrow pin point stream is very powerful. It is not recommended ...
Warning: if automatic total stop® fails to operate, do not use the machine. Contact our customer service department. Further use will damage the machine and/or cause personal injury. Warning: the pressure washer is also equipped with a main power on/off switch located on the unit. It should always b...
Warning: to reduce the risk of electrocution, keep all connections dry and off the ground. Do not touch plug with wet hands. 6 power supply and electrical info the pressure washer is factory-equipped with an electrical cord and a ground fault circuit interrupter (gfci) power plug. This cord should o...
High pressure hose on/off switch detergent regulator dial high pressure outlet pressurized hose reel garden hose connector spray gun cord storage hook 35 ft power cord with gfci turbo spray nozzle storage compartment gun/lance holders dual detergent tanks variable spray lance 1 1 1 1 1 1 1 1 1 1 1 1...
Assembly instructions 1. Slide the storage hook onto the back of the machine as shown in fig.1 8 fig. 1.
Step 1 operating instructions remove the shipping plug(s) from the front of the machine. 9 fig. 4 step 2 connect the high pressure hose to the machine outlet. To connect, carefully insert the l-shaped connector fitting with the o-ring into the high pressure outlet and tighten the threaded nut by han...
Step 4 operating instructions insert the spray lance into the gun by pushing firmly and simultaneously twisting 1/4 of a turn until locked into place. 10 fig. 4 step 5 connect the garden hose to water supply and turn water on. Step 6 plug gfci into power receptacle. Firmly press and release the test...
Step 7 operating instructions before turning unit on, squeeze and hold trigger to bleed any trapped air out of the unit. Release trigger when water flow is steady. 11 fig. 4 step 8 depress the on button. Note that the motor will momentarily start and then stop. Step 9 squeeze the trigger to start mo...
Warning: do not touch the nozzle to adjust pressure while the trigger is squeezed. Warning: risk of injection or injury. Do not directly discharge stream at anyone. Warning: if the lance and nozzle are not securely locked into place, they could be ejected under high pressure when operating the gun. ...
Caution: the pencil point spray adjustment is very aggressive. We recommend that for most cleaning applications a 20° spray angle be used to avoid damage to the surface being cleaned. Operating instructions 13 the variable spray nozzle can adjust from fan to pencil point spray in both the high and l...
Caution: use only approved pressure washer cleaners. Do not use bleach, chlorine, or any cleaners containing acids. Operating instructions 14 1) remove the tank cap(s) (1-2) present on the back of the machine. (fig.16) 2) fill the detergent tank(s) with suitable cleaning solution. 3) turn dial to ch...
End of use and winter storage instructions 15 1) when finished using the pressure washer, you must first drain and rinse the detergent tanks. 2) run the pressure washer in low pressure until all of the detergent is drained from the detergent tanks. 3) pour clear water into the tank(s) and run it thr...
Care and maintenance 16 connections caution: if the screen is not kept clean, the flow of water to the pressure washer will be restricted and the pump may be damaged. Connections on pressure washer hose, gun and spray wand should be cleaned regularly and lubricated with non-water soluble grease to p...
Troubleshooting 17 problem possible cause correction motor will not start or stops while operating. Defective gfci. Perform gfci reset procedure. See operator’s manual page 6. Extension cord length or gauge incorrect. Use proper extension cord. See operator’s manual page 6. Loose or disconnected plu...
Warranty 18 this product is warranted against defects in material and workmanship for a period of one year on all components excluding the gun, hose, lances, nozzles, and ground fault circuit interrupter (gfci) which are only covered for 90 days; effective from the date of retail purchase and is not...
