TATA Motors Sumo Victa Di Turbo Owner's Manual - page 62
59
AIR CONDITIONING
AIR CONDITIONING
AIR CONDITIONING
AIR CONDITIONING
AIR CONDITIONING
Once temperature inside has come down sufficiently, close
the windows and change air circulation suitably to fresh/
recirculation.
Demisting :
Demisting :
Demisting :
Demisting :
Demisting :
In rainy season or in areas of high humidity, mist formation
inside windshield glass is observed. To clear mist dehumidified
air is passed on the windshield glass.
The position of control knobs should be adjusted as follows :
A.C.
- ON
Knob 'B'
- Desired speed position
Knob 'C'
- Towards windshield
Knob 'A' (for vehicles fitted with HVAC) - at suitable temperature
Air circulation - at suitable position
NOTICE
NOTICE
NOTICE
NOTICE
NOTICE
When mist gets cleared switch the knob "C' position to Face
mode. In high humidity areas, if cold air continues to flow
over windshield, it may cause sudden fogging on outside
surface of windshield.
D
D
D
D
Defr
efr
efr
efr
efrosting :
osting :
osting :
osting :
osting : (For vehicles fitted with HVAC unit)
In low temperature areas, to clear frost formation outside
the windshield glass, this setting is used.
First start the engine and accelerate to warm up.Knob
'A'
- Maximum hot position
Knob 'B'
- Very High
Knob 'C'
- Towards windshield
Switch 'E'
- Fresh air mode condition
Once the windscreen has become clear, move the fan
switch to desired speed.
NOTICE
NOTICE
NOTICE
NOTICE
NOTICE
Electric heater coil is provided for demisting of tail gate
glass for deluxe versions.
N
N
N
N
Nor
or
or
or
ormal H
mal H
mal H
mal H
mal Hea
ea
ea
ea
eating :
ting :
ting :
ting :
ting : ( For vehicles fitted with HVAC )
Knob 'A'
- Suitable temperature position
Knob 'B'
- Suitable blower speed
Knob 'C'
- Towards face & feet
A . C .
- OFF
Air Circulation- Fresh switch