TATA Motors tigor Owner's Manual - page 28
OPENING AND CLOSING
26
Bonnet
Opening
WARNING
Always switch off the windshield wip-
ers and the ignition before opening
the bonnet.
WARNING
Certain components in the engine
compartment, such as the engine, ra-
diator and parts of the exhaust sys-
tem, can become very hot. Working in
the engine compartment poses a risk
of injury.
1.
Ensure that the vehicle is in neutral
gear with the parking brake applied.
2.
Pull the bonnet release lever. The
bonnet will pop up slightly.
3.
Raise the bonnet slightly and with
your finger slide the secondary lock
lever located under the bonnet cen-
tre to the left side.
NOTE
Make sure that the wiper arms are
not raised before you lift up the bon-
net to avoid damaging the wiper
arms and the bonnet.
4.
Lift the bonnet up. Pull the bonnet
stay rod from its clip and insert the
free end into the slot.
WARNING
The stay rod can be hot enough to
burn your finger right after driv-
ing. Touch the rod after it be-
comes cool enough.
Insert the stay rod into the hole
securely. If the rod drops off, your
body may be caught below the
bonnet.
!
!
!