Tag-2 camera quadri-linear reference manual © 2005 by tattile s.R.L. Eng.
Version__03.00.00 (november 2005) © 2005 by tattile s.R.L. The gige® logo is registered mark of the automated imaging association. All tattile's systems were created to be alive, smart and open products. Therefore, we give you the chance to update features and capabilities during the whole life cycl...
Index mechanical dimensions.....................................................................................................................4 connectors and indicators.................................................................................................................5 general charac...
Tag-2 camera mechanical dimensions note: to fix use only m4 screws, appling 1,55 nm force. 4.
Tag-2 camera connectors and indicators rear view 5.
Tag-2 camera general characteristics 6 +24v 9 w processor: flash sdram micro ip42 tag-2 camera 0v 0°c +50°c -10°c +65°c characteristics electric characteristics power supply power consumption sensor linear ccd sensor digital inputs 2 optoisolated inputs 24vdc 20ma digital outputs 2 pnp optoisolated ...
Tag-2 camera ccd general characteristics ccd specifications 7 parameters value total number of pixels 3x4134 chroma 1x8292 luma number of effective pixels 3x4128 chroma 1x8276 luma number of active pixels 3x4080 chroma 1x8160 luma pixel size 10 µm (h) x 10 µm (v) chroma 5 µm (h) x 5 µm (v) luma pixe...
Tag-2 camera picture 1 - sensor typical responsivity 8.
Tag-2 camera interface connection power interace connector 9.
Tag-2 camera ethernet connector 10
Tag-2 camera ethernet connection cables 11.
Tag-2 camera example of connection standalone connection the tag-2 camera can be connected directly to a pc using an ethernet cross-over cable. The operator uses the pc to configure applications and monitor runtime operation. In this configuration, the camera is isolated from the factory network. No...
Tag-2 camera note: for connection between pc and switch/router and between switch/router and tag-2 camera use ethernet direct cables. The tag-2 camera can be connected to a network factory, by using a network router or an ethernet switch. Note: for connection between pc and switch/router and between...
Tag-2 camera instructions for a right installation of tattile control equipment good equipment operation is guaranteed only by respecting the instructions cited in this refer- ence manual. Tattile declines all responsibility for anomalous equipment operation, installed with criteria not respecting t...
Tag-2 camera warning! The warranty covering tattile equipment is invalidated when : 1. The equipment has been opened or tampered with. 2. Faults due to incorrect connection of power or input/output circuits. 3. Faults due to overload or non-compliance with equipment's rated specifications. 4. Applic...
Tag-2 camera revisions the revision index is reported below. The various revisions can contain additional information or corrections of printing errors. Rev. Date page description prepared checked approved 03.00.00 december 2005 all first release nicola g. G.Gualeni nicola f. 16.